Lenmar OmniSource Li-Ion Quick Manual

OmniSource® Li-Ion

Universal Charger for
Li-Ion Camcorder Batteries

PLEASE READ THE INFORMATION AND FOLLOW ALL
INSTRUCTIONS THOROUGHLY BEFORE US I NG THIS PRODUCT.

Introduction

The OmniSource Li-Ion is a fully automatic camcorder battery charger which
is compatible with virtually all 3.6 volt and 7.2 volt Lithium-Ion batteries for
8mm, VHS-C & digital camcorders from Sharp, Sony, Canon, JVC,
Panasonic, RCA and other manufacturers. In addition to the adapter plates
included, you can also purchase additional adapter plates for other Li-Ion
battery models.

This unit uses an advanced charging circuit, which provides a safe, full
charge every time. “Charging” and “Full Charge” status of the battery is
shown on the built-in LED indicator.

Flexible power input allows you to use the OmniSource Li-Ion from home
with its AC Power Supply or on the road using the DC Cigarette Lighter
Adapter included. Avoid prolonged use in an automobile when the engine is
not running as it may drain the battery in the vehicle.

Operation:

1. Plug-in, either the AC 110V or the DC Cigarette Lighter power adapter,

depending on where you are going to use your OmniSource Li-Ion charger
unit. Connect the other end of the power adapter cable to the power input
socket on the charger unit.

2. C hoose the adapter p la te for the type of Li-Ion (Lithium-Ion) battery you

will be charging. Attach the selected adapter plate to the charger unit by
aligning the slots on the adapter plate bottom with the fingers on the
charger base. While pressing down lightly on the adapter plate, slide the
plate toward the front of the cha rger base until it locks. Then, sl ide the
battery to be charged onto the adapter plate.

3. Once the battery has b een properly connected to the charger unit, the

charge indicator will glow Red to indicate that this unit has begun to
charge your battery. When the battery is fully charged, the LED will
change from Red to Green indicating the battery is full and charge is
complete. Remove the battery from the charger.

Note: It is normal for the charger or the battery to become warm during
recharging.

Trouble Shooting Tips:

• If the Red LED (CHG) indicator does not light up when the charger is

plugged with power and battery has been attached, the battery contacts
may not be touching contacts on base unit. Unplug the unit and check
connection of the battery to the charger. Also, make sure the adapter
plate is the proper one and that it is securely attached to the charger
base.

• Use a clean dry cloth when necessary to keep the metal contacts of both

charger and battery clean.

Cautions:

• For use with Lithium-Ion (Li-Ion) batteries ONLY! Use with other type

batteries voids warranty, may cause damage to the charger/ battery and
possibly cause injury to the user.

• Recharge Li-Ion batteries after use and before being put away.

• Do not leave battery attached to camcorder when camcorder is not to

being used.

• Do not leave the battery connected to the charger for prolonged periods.

Remove the battery after charge is complete.

• Unplug the charger when not in use.

• Do not use, place or store the charger where it may come into contact

with water or moisture.

• Always replace frayed or damaged wire and broken plugs immediately.

• Use this charger with the AC adapter included in the package only.

• It is not necessary or recommended to discharge a Li-Ion prior to

charge.

Note: Batteries will self discharge when not in use whether they are attached
to a camcorder or not. Batteries can be kept fresh if you recharge them every
2-3 months, if not being used.

Battery Charge Times:

3.6V Battery Capacity Approx. Chg. Time
1400 mAh 190 minutes
2600 mAh 340 minutes
4050 mAh 550 minutes

7.2V Battery Capacity Approx. Chg. Time
800 mAh 75 minutes
1500 mAh 140 minutes
2700 mAh 250 minutes
4050 mAh 380 minutes

Specifications:

Power Input - 12-18 VDC @ 800-1000 mA
Charge Method - Constant Voltage -

Rapid Charge, Switching to

“Trickle Charge” when full.

Limited 1 Year Warranty

This limited warranty starts from the date of original purchase and expires 1 year
thereafter.

If any part, because of manufacturing defects or workmanship fails to function properly
under normal use will be r epaired at no charge for parts and labor or, at our option, the
produc t will be re placed. The following is excluded: damages from delay or loss of use of
equipment, or damaged batteries, malfunctions resulting from misuse, tampering,
unauthorized repairs, modifications, or accident.

Package the unit and its accessories carefully using ample padding material to prevent
damage in transit and ship it prepaid and insured to:

LENMAR ENTERPRISES INC. USA , 31328 VIA COLINAS #102, WESTLAKE
VILLAGE, CA 91362.

When sending in product for service, your package should include evidence of date and
place of purchase. Enclose $7.50 for shipping and handling for addresses in the U.S. and
$12.50 in Canada. For outside the U.S. and Canada, freight will vary depending upon ship
to address.

Visit our web site at: www.Le nmar.com