Lenmar Maven BC6S, Maven BC6B, Maven BC6R User Manual

PLEASE READ THIS INFORMATION THOROUGHLY BEFORE USING
THIS PRODUCT. IT CONTAINS IMPORTANT OPERATING
INSTRUCTIONS FOR YOUR UNIT. FAILURE TO HEED THESE
WARNINGS MAY RESULT IN AN UNDEAD UPRISING.
Model: BC6/S/R/B
MAVEN - iPhone 6 Power Case
WHAT’S INCLUDED:
UNDEAD RULES
Rule1. Remove any screen protectors on the back side of your iPhone 6 before installing it into your Maven.
Rule 2. Charge the Maven fully prior to initial use. Rule 3. For maximum battery life, disconnect the battery once it is fully
charged. Rule 4. Do not disassemble. Do not attempt to open the battery casing; there are no user serviceable parts. This will void the warranty. Rule 5. Do not submerge. Keep the Maven dry at all times. If the Maven gets wet while in use, immediately remove your iPhone 6 from the Maven and turn the Maven off. Do not attempt to use the device again until you have verified that it is completely dry and in working order. Rule 6. Keep the Maven away from flammable and heat-sensitive materials, fumes, gasses, brimstone, and nuclear waste. Rule 7. Do not store the Maven at temperatures above 60°C (140°F) or below -20°C (-4°F) or in locations where the relative humidity exceeds 90%. Rule 8. Avoid placing the Maven in direct sunlight for prolonged periods of time. Do not place battery in fire or other excessively hot environments. Rule 9. Recycle or dispose of the Maven properly. If disposed of incorrectly, the power case may leak or explode, causing personal injury.
You’ve officially made the leap from dead to undead with the MAVEN Power Case for iPhone 6. You’ll never find yourself scavenging for an available outlet. With the push of a button power-up your phone anytime, ANYWHERE. Congratulations, you’re undead.
This case is MFI certified and meets all Apple performance and quality standards.
BECAUSE POWER IS EVERYTHING
INSTALLING YOUR IPHONE 6 INTO THE CASE
Before installing your iPhone 6 into the Maven make sure screen protectors have been removed from the back side of the iPhone 6.
USB
2
1
Prior to initial use, follow the instructions below to charge the MAVEN completely.
Charge the Maven using the included Micro USB cable. Plug the Micro USB cable into the Micro USB port on the bottom of the Maven. Plug the USB end into your computer’s USB port, a USB wall adapter, a USB car adapter, or an external battery pack.
When charging the Maven with the iPhone 6 installed, the iPhone 6 battery will fully charge first and the Maven will charge second.
CHARGING THE MAVEN
HOW TO GO FROM DEAD TO UNDEAD
LED INDICATOR: CHARGING STATUS
As the above percentages are reached, the corresponding LED will go from FLASHING to SOLID.
25%-50%
50%-75% 75%-99%
99%-100%0%-25%
FLASHING
Slide your iPhone 6 into the bottom piece of the case until it clicks into place. Be sure to line up the iPhone 6 charging port with the Maven lightning connector. Then align the top half of the case and slide it down.
NOTE: If it is hard to slide your iPhone 6 into the Maven, STOP. This means your iPhone 6 is not lined up correctly with the lightning connector inside the Maven.
LIGHTNING
CONNECTOR
To turn the Maven “ON”, depress the button on the back of the case for 3 seconds, the LEDs will light up and your iPhone 6 will indicate that it is charging.
To turn the Maven “OFF”, depress the button on the back of the case for 3 seconds. Your iPhone 6 will stop charging.
To charge your iPhone 6, depress the power button for 3 seconds, the LEDs will light up and your iPhone 6 will indicate that it is charging.The battery “lightning” icon on the top right of your iPhone 6 will appear.
CHARGING YOUR IPHONE 6
4
POWER BUTTON
3
ON/OFF BUTTON
LED
STATUS
INDICATOR
CHARGING
INDICATOR
The headphone extension cable may be used with any headphone plug. To use the headphone extension cable, plug the end of your headphone cable into the extension cable. Then, plug in the other end of your extension cable into the headphone jack of the Maven.
Sync your iPhone 6 to iTunes without removing the Maven. Using the Micro USB cable, connect the Maven to the computer with your iPhone 6 installed. The LED lights will flash while your iPhone 6 is syncing with the computer.
EXTENSION CABLE
HEADPHONE PLUG
USING THE HEADPHONE EXTENSION CABLE
5
SYNC
6
To check the remaining capacity of the Maven, quickly depress the power button. When the Maven is at less than 5% of its capacity only the last green LED will start to flash which indicates the Maven is low and in need of a charge.
LED INDICATOR: PERCENTAGE OF CHARGE REMAINING
0%-5%
FLASHING
5%-25%
SOLID
25%-50%
SOLID
50%-75%
SOLID
75%-100%
SOLID
Carefully remove the top cover by gripping the sides of the top piece and pulling the top up from the bottom of the case.
Once the top piece is removed, slide your iPhone 6 up and out of the Maven. While holding down the bottom half of the Maven, grip the sides of the iPhone 6 as shown in the diagram and pull straight up.
If you have difficulty removing your iPhone 6 from the Maven, do NOT insert anything into the headphone jack. Doing so may damage your iPhone 6 and the Maven.
REMOVING YOUR IPHONE 6 FROM THE MAVEN
7
LIMITED 1 YEAR WARRANTY
Lenmar products are warranted to be free of defective parts and workmanship for a stated period from the original date of purchase when sold through our website or our authorized retailers. Warranties are not transferable. The warranty excludes damage resulting from accident, misuse, modification, delay or loss of use, damage to equipment or by normal wear and tear.
ALL WARRANTY CLAIMS ARE PROCESSED ONLINE AT THE FOLLOWING LINK: WWW.LENMAR.COM/WARRANTY
Cell Type: Lithium-Polymer Battery Input: DC 5V2A Output: DC 5V1A Capacity: 3000mAh Compatibility: 4.7” iPhone 6 Standby: Up to 11 days* 3G Talk Time: 15.4 hrs.
SPECIFICATIONS
Internet Use: Up to 11 hours and on the 3G/4G LTE, Up to 12 hours on Wi-Fi. Audio Play: Up to 55 hours* Video Play: Up to 12 hours* Dimensions: L 152.2 x W 71.2 x T 15.3mm Weight: 95.6g
*All above times can vary due to device settings, location, and signal strength
REGISTER: FOR A REPLACEMENT PART
Proposition 65 Notice (California)
The following statement is required in the state of California pursuant to the settlement of an action brought by the Mateel Environmental Justice Foundation against multiple electronics and appliance manufacturers.
Lenmar was founded in California in 1965. In the ensuing decades the company has been responsible for bringing millions of consumer electronics back from the dead. Our products are designed locally and consumed globally, with headquarters in North America, Europe, and Asia. In an increasingly connected world, where thousands of mobile phone, tablet, camera, and laptop batteries die every second, keep your favorite electronics UNDEAD with Lenmar.
For questions, comments, and to explore Lenmar's Undead Power solutions, please visit our website at www.lenmar.com or call customer service at 800-424-2703 from 8AM to 5PM PST.
Important: Register your product on lenmar.com to be eligible for one free replacement part if needed (charging cable, headphone extension cable or top piece).
• WARNING: Handling the cord on this product will expose you to lead, a chemical known to the state of California to cause birth defects or other reproductive harm. Wash hands after handling.
Lithium-Polymer battery must be recycled or disposed of properly.
iPhone 6 is an Apple registered trademark.
314-238-07-1216 r1 y1
STAY CONNECTED
instagram.com/LiveLenmar
facebook.com/LiveLenmar
youtube.com/LiveLenmar
twitter.com/LiveLenmar
pinterest.com/LiveLenmar
lenmar.com
Loading...
+ 16 hidden pages