Page 1
X2 北美版说明书
Infrared sensor
SIM card slot
Menu
Le Max2
Notification LED
Home
USB type-C port
(Charging, headset interface)
Front camera
Volume
Power
Back
SIM Card Installation
Insert the pin
into the pinhole
Use SIM card eject pin to remove
the card tray.
Install SIM card(s) Insert SIM card tray
Only st a ndar d Nan o SIM is
supported. I nserting a modified
card may damage the card slot.
Dual SIM Dual Standby：While one
SI M c ar d is using 4G/ 3G /2 G
services , the other uses 2G(GSM)
voice call only.
Eject SIM
card tray
Eject SIM card trayInsert SIM card eject pin
befor e ejecting the ca rd tray t o
avoid possible dama ges to y our
device.
Insert SIM
card tray
Place the SIM card on the card tray
with the m et al s id e f acin g
downwards.
Insert th e card tray back into the
slot until it is locked in place.
Account Activation
21
Le Eco, you need to regis ter or log in to a Le Eco
account.
Register a LeEco Account:
Naviga te to My LeEco > Lo g in to LeEco accou nt >
Register to create a new LeEco account and set the
password. Once activated, you ca n sign in with the
account.
Log in to Your LeEco Account:
Naviga te to My LeEco > Lo g in to LeEco accou nt >
Login, and then enter your account name and password to log in.
Safety Information
3
FCC 1g SAR Limit（1.6 W/kg）
Head：
1.09/kg （1g）
Body ：1.11 /kg（1g）
HAC: M4/T3
Charger safety
Charger sh ould be used near the de vice and shall be easily
accessible. Users have to use the connection to USB interfaces
with USB 2.0 version or higher.
Battery safety
Caution: Ris k of explosion if ba ttery replaced by an incorrect
type. Dispose of used batteries as instructed.
Operating environment
Please make sure the env ironment temperature for charger and
device will not be higher than 35℃
RF Exposure Information (SAR)
4
This m obile phone meets the government ’ s require ments for
exposure to radio waves.
This phone is designed and manufactured no t to exceed the
emission limits for exposure to radio fre quency (RF) energy set
by the Federal Communications Commission of the U.S. Gover n
ment.
The exposure s tandard for wirele ss mobile phones employs a
unit of measurement known as the Specific Absorption Rate, or
SAR. The SAR limit set by the F CC is 1.6W/kg. *Tests for SAR
are conducted using standard operating positions accepted by
the F CC with th e phone transmitting at its high est certifie d
power level in all tested frequen cy bands. Although the SAR is
determined at the highest certified power level, the actual SAR
lev el of the phone while ope rat ing can be well be low t he
maximum value . This is bec ause the phone is designed t o
ope rate at multi ple power levels so as to use o nly the poser
required to reach the network. In general, the closer you are to a
wireless base station antenna, the lower the power output.
The highest SAR value for the model phone as reported to the
FCC when tested for use at the ear
on the b ody, as describe d in thi s us er guide, is 1.11 /kg
depending upon available accessories and FCC requirements.)
var ious phones and a t various po sitions, t hey all meet the
government requirement.
The FCC has granted an Equipment Authorization for this model
phone with all repor ted SAR levels evaluated as in c ompliance
with the FCC RF exposure guidelines. SAR inform ation on this
model phone is on file with the FCC and can be found under the
Display Grant section of www.fcc.gov/oet/ea/fccid after search
ing on FCC ID: 2AFWMLEX829.
For body worn operation, this phone has been tested and meets
the FCC RF exposure guidelin es for use with an accessory that
contains no metal and the positions the handset a minim
cm from the body. Use of other accessories may not ensure
compliance with FCC RF exposure guidelines. If you do no t use
a body-worn accessory and are not holding the phone at the ear,
position the handset a mini mum o
the phone is switched on.
is 1.09/kg
c
m from
f 1.5
and when worn
um of 1.5
y
body wh
ou
r
e
n
but an integrated Internet ecosystem
I'm not just a phone,
FCC Regulations
5
This mo bile phone complie s with part 15 of the F CC Rules.
Operation is subject to the following two conditions: (1) T his
device may not caus e harmful interference, and (2) this device
must accept an y interference received, including interferen ce
that may cause undesired operation.
This mobile phone h as been tested and foun d to comply with
the limits for a Class B d igital device, pursuant to Part 15 of the
FCC Rules. These limits are designed t o provide reas onable
protection against harmful int erference in a residential installation. This equipment generates , uses and can radiated radio
frequenc y energy and, if not installed and used in accordance
with the inst ructions, may cause harmful interferenc e to radio
communicatio ns. However, there is no guarantee that in terference will not occur in a particular installation If this equipmen t
does cause harmful interference to radio or television reception,
the user is encou raged to try to correct th e interference by one
or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
that to which the receiver is connected.
-Consult the dealer or an experienc ed radio/TV technician for
help.
FCC Caution:
Any Changes or mo difications not e xpressly approved by the
party responsible for compliance could void the user ‘s authority
to operate the equipment.
The antenna(s) used for this transmitter must not be co-located
or operating in conjunc tion with any other antenna or transmitter.
Note: The country code selection is for non-US model only an d
is not available to all US model. Per FCC regu lation, all W iFi
product marketed in US must fi xed to US op eration channels
only.
The declaration of conformity may be consult at：
Manufacture Name：Lemobile Informa tion Technology (Beijing)
Co., Ltd
Manufacture Address ：WENHUAYING NORTH (No.1, LINKONG
2nd St)， GAOLIYING， SHUNYI DISTRICT，BEIJING
FCC ID: 2AFWMLEX829
IC: 21242-LEX829
ISED Notice
This device complies with Innovation, Science and
Economic Development Canada license-exempt RSS
standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
-
Le présent appareil est conforme aux CNR Innovation,
Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions
suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d'en
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
IC: 21242-LEX829
ISED Radiation Exposure Statement
This EUT is compliance with SAR for general
population/uncontrolled exposure
limits in IC RSS-102 and had been tested in accordance
with the measurement
methods and procedures specified in IEEE 1528 and IEC
62209. This equipment
should be installed and operated with minimum distance
1.5 cm between the
radiator and your body. This device and its antenna(s)
must not be co-located or
operating in conjunction with any other antenna or
transmitter.
-
Cet appareil est conforme aux limites d'exposition DAS
incontrôlée pour la population
générale de la norme CNR-102 d'Industrie Canada et a été
testé en conformité avec
les méthodes de mesure et procédures spécifiées dans
IEEE 1528 et IEC 62209.
Cet appareil doit être installé et utilisé avec une distance
minimale de 1.5 cm entre
l’émetteur et votre corps. Cet appareil et sa ou ses
antennes ne doivent pas être
co-localisés ou fonctionner en conjonction avec tout
autre antenne ou transmetteur.
The devi ce is go ing on be op erate d in 5150MHz- 5250MHz
frequency range. It is restricted indoor environment only.
Hearing Aid Compatibility (HAC) regulations for
6
Mobile phones
In 2003, the FCC adopted rules to make digital wireless
telephones compatible with hearing aids and cochlear
implants. Although analog wireless phones do not
usually cause interference with hearing aids or cochlear
implants, digital wireless phones sometimes do because
of electromagnetic energy emitted by the phone's
antenna, backlight, or other components. Your phone is
compliant with FCC HAC regulations (ANSI C63.19-
2011). While some wireless phones are used near some
hearing devices (hearing aids and cochlear implants),
users may detect a buzzing, humming, or whining noise.
Some hearing devices are more immune than others to
this interference noise and phones also vary in the
amount of interference they generate. The wireless
telephone industry has developed a rating system for
wireless phones to assist hearing device users in finding
phones that may be compatible with their hearing
devices. Not all phones have been rated. Phones that are
rated have the rating on their box or a label located on
the box. The ratings are not guarantees. Results will vary
depending on the user's hearing device and hearing loss.
If your hearing device happens to be vulnerable to
interference, you may not be able to use a rated phone
successfully. Trying out the phone with your hearing
device is the best way to evaluate it for your personal
needs.
This phone has been tested and rated for use with
hearing aids for some of the wireless technologies that it
uses. However, there may be some newer wireless
technologies used in this phone that have not been
tested yet for use with hearing aids. It is important to
try the dierent features of this phone thoroughly and in
dierent locations, using your hearing aid or cochlear
implant, to determine if you hear any interfering noise.
Consult your service provider or the manufacturer of
this phone for information on hearing aid compatibility.
If you have questions about return or exchange policies,
consult your service provider or phone retailer.
M-Ratings: Phones rated M3 or M4 meet FCC
requirements and are likely to generate less interference
to hearing devices than phones that are not labeled. M4
is the better/higher of the two ratings.
T-Ratings: Phones rated T3 or T4 meet FCC
requirements and are likely to be more usable with a
hearing device’s telecoil (“T Switch” or “Telephone
Switch”) than unrated phones. T4 is the better/ higher
of the two ratings. (Note that not all hearing devices
have telecoils in them.)
Your phone meets the M4/T3 level rating.
Hearing devices may also be rated. Your hearing device
manufacturer or hearing health professional may help
you find this rating. For more information about FCC
Hearing Aid Compatibility, please go to http://www.fcc.gov/cgb/dro.
Le X829 Quick Start Guide
Size: 254*127.5mm，成品尺寸： 63.5*127.5mm
Material: 80g 哑面铜版纸
Craft: 牙刀 圆角模切，折页，压线
Color mark: 4c+4c
Le 2 Quick Start Guide
王少维
武蓉
潘林
吴常春
王成森
韩光明
X2
206200002751
说明书-裕同
V1.0
2016.04.11
Loading...