Page 1
Instrucon Manual
Bar Refrigerator
RQ-115M
Page 2
1.Name of parts1.Name of parts
1
2
3
PARTS AND FEATURESPARTS AND FEATURES
12
11
10
4
9
5
6
7
8
Cabinet Cabinet
Freezer Compartment Door Freezer Compartment Door
Drip TrayDrip Tray
Shelves Shelves
Glass coverGlass cover
Compressor(back)Compressor(back)
Crisper boxCrisper box
Leveling LegsLeveling Legs
Bottle RacksBottle Racks
Recessed HandleRecessed Handle
1010
1111
Door switchDoor switch
1212
Temperature Control Knob Temperature Control Knob
1
Page 3
2.Correctly positioning 2.Correctly positioning
Well Ventilating
There is need of good ventilation around the refrigerator for easy
dissipation of heat, high efficiency of refrigeration and low power
consumption. For this purpose, sufficient clear space should be
need around the refrigerator. Its back is at least 100mm away from
the wall, its sides at least have a space of 100mm separately and
the height from over its top is not less than 200mm. A clear space
should be left to open its doors to 160
Power Supply
The refrigerator is only applied with power supply of single phase
alternating current of (220-240)V~/50Hz;230V~/60Hz.If fluctuation
of voltage in the district user is of so large that the voltage
exceeds the above scope, for safety sake, be sure to apply a.c.
automatic voltage regulator to the refrigerator. The refrigerator
must employ a special power socket instead of common one with
other electric appliances. Its plug must match the socket with
ground wire.
(+220-240)V~(+220-240)V~
230V~ 230V~
__
++
50Hz50Hz
60Hz60Hz
¡À¡À
¡À¡À
10%10%
10%10%
Power Line Cord
The cord should be neither lengthened nor folded into
coil during operation. Moreover, it is forbidden that cord
is kept close onto the compressor at the back of the
refrigerator, the surface temperature of which is quite
high when operating. Touching with it would deactivate
the insulation or cause leakage for electricity.
Protection from Moisture
Avoiding placing the refrigerator in a place where heavy
moisture is present so as to minimize possibility of rusty
for its metal parts. Still more, the refrigerator is forbidden to
be directly sprayed by water, otherwise, poor insulation and
current leakage would occur.
NN
Page 4
2.Correctly Positioning2.Correctly Positioning
Protection from Heat
The refrigerator should be far away from any heat
source or direct sunshine.
Fixing Stable
Floor on which refrigerator will be placed must be flat
and solid. It should not be laid on any soft material such as
foam plastic, etc. If the refrigerator is not on the same level,
adjust the screws suitably. The refrigerator should not be
placed near anything which may echo.
Keep Away from Danger
It is inadvisable that the refrigerator is placed near
any volatilizable or combustible such as gas, petrol,
alcohol, lacquer and banana oil, etc. The above-mentioned
objects can not be stored in the refrigerator.
Moving
When fixed or moved, the refrigerator can not be
set horizontally or declined to more than 45 or
upside-down.
Page 5
3.Cautions3.Cautions
Water contained in food or getting into air inside the refrigerator by opening doors
may form a layer of frost inside, It will weaken the refrigerator when the frost is thick,
while it is more than 2mm thick, you should defrost.
Defrosting in freezer chamber is operated manually. Before defrosting, take the food,
the ice tray and the shelf out into the cold storing chamber temporarily then set the
knob of the temperature regulator to position"0"(where the compressor will stop working)
and leave the door open until ice and frost dissolve thoroughly deposited at the bottom
drip tray of the freezer chamber. Take out the drip tray and discard the water carefully.
In the case of speeding up the defrosting, you may put a bowl of warm water (about 50 C )
into the freezer chamber, and be sure to set the knob of the temperature regulator to
original position after defrosting.
It's inadvisable to heat the freezer chamber directly with hot water or hair dryer while
defrosting to prevent deformation of the inner case.
It's also inadvisable to scrape of ice and frost or separate food from the containers
which have been congealed together with the food with sharp tool or wooden bars,
so as not to damage the inner casing or the surface of the evaporator.
If the supply cord of this appliance is damaged, it must only be replaced by a repair
shop appointed by the manufacturer, because special purpose tools are required.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety
Children should be supervised to ensure that they don't play with the appliance
44
Page 6
4.Changing the reversible door4.Changing the reversible door
This refrigerator has been built with the door hinges on the right. If you wish
to change the opening direction, follow the instructions below:
1. Remove the upper hinge cover(6) first
2. Remove the two screws (1) that hold the upper hinge (5) (right side) to the
frame. Take away the upper hinge (5).
3.Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws(8) that hold the lower hinge(2) and Make sure to
Remove the lower hinge(2).
5. Remove the left front leg (4) and transfer it to the right side.
6. Remove the hole cover plate(7) to the right side.
Before placing this lower hinge(2), remove the bolt-pin (9) and reverse
7.
the direction of the lower hinge(2). Then install the lower hinge (2) onto
the left side of the lower frame with two screws (8).
.
8. Insert the bolt-pin(9) to the lower hinge (2).
9. Set the door to its place making sure the door seat at the lower hinge(2)
.
10..While holding the door in the closed position secure the upper hinge (5) in the
top frame of left side with two screws (1). Please remember that do not tighten
the two screws(1) until the top of the door is levelled with the counter top.
11. Install the upper hinge cover(6) on the upper hinge..
55
Page 7
11
66
77
55
22
11
55
77
66
88
44
99
33
22
88
33
44
99
66
Page 8
5.Maintenance 5.Maintenance
The refrigerator should be cleaned and maintained once a month.
When performing maintenance, make absolutely sure that the power plug
is first disconnected from the power outlet.
Wipe the inner and outer surface of the refrigerator and its accessories with
wet cloth. If they are too dirty, scrub them with neutral detergent, and then
clean them with water and dry them with clean cloth. After this, a small
quantify of glass wax is recommended to polish the refrigerator surface with
a flannelette.
For cleaning, don't use hot water, diluent, petrol, alcohol, kerosene, washing
powder, cleanser, aikailinous detergent, acid, Chemical cloth, etc. So as not
to damage the lacquer coat and plastics. It is forbidden than the refrigerator
is directly sprayed with water. Otherwise, it would cause rusty or weaken the
insulation.
Be careful to upkeep the sealing rubber bars of the doors. They should always
be cleaned.
If the plastic parts in refrigerator remain contaminated for a long time by oil
(animal or vegetable), they will be easy aged and possibly cracked. The drain
pan gets dirty very easily if it is not cleaned regularly, bad odours will be produced, get into the habit of cleaning this pan regularly.
77
Page 9
6. Troubleshooting
1. When the refrigerator does not work
Check if there is a power failure.
Check if the power plug is plugged into the power outlet.
Check that the fuse has not blown.
2. When the refrigerator is cooling excessively
The temperature control dial may be set too high.
If you place foodstuffs containing a lot of moisture directly under the cool
air outlets, they will freeze easily. This does not indicate a malfunction.
3. When the refrigerator is not cooling sufficiently
The food may be packed too tightly together which will block the flow of cool air.
You may have put something hot or a lot of foodstuffs into the refrigerator .
The door may not have been closed properly.
The door gaskets may be damaged.
The refrigerator may not be ventilated.
There may be insufficient clearance between the refrigerator and the surfaces
Immediately both sides and above.
The temperature control dial may not be set properly.
4. When the defrosting water overflows inside the refrigerator and onto the floor.
Check that the drain pipe and the drain hose are not clogged.
Check that the drain pan is housed properly.
5. When condensation form on the outside of the refrigerator.
Condensation may form on the outside when the humidity is high such as during
a wet season. This is the same result as the condensation formed when chilled
water is poured into a glass. It does not, therefore, indicate a failure, wipe dry
with a dry cloth.
6. When you hear a sound like water flowing .
A sound like water flowing is the refrigerant flowing. It does not Indicate a
malfunction.
7. When the cabinet's side panel heats up
The side panel of the cabinet will heat up when the door is opened or closed
frequently, when starting the unit and when the unit operates in summer with
high ambient outside temperature, In such case, do not touch the panel, it
results from the dissipation of the heat from inside the cabinet, and it does
not mean that something is wrong with the refrigerator.
8
Page 10
7.Technical specifications7.Technical specifications
*For the detailed technical specifications, please refer to the nameplate at
the back of the refrigerator..
*Specifications are subject to change without prior notice.
9 9
Page 11
temperture lowquckly and save the power
cracking.
“strong” position
Trouble shooting guide
The door can not close
No Problem Possible Cause What To Do
Not plugged in. Plug in
The refrigerator does
1
not get cold at all.
The refrigerator does
2
not get cold enough.
The food in the
3
refrigerator is frozen
Two sides of the
4
cabinet are hot:
condensation occurs.
Is the circuit breaker tripped or blown fuse?
Is the refrigerator temperature control setted at
“off”?
Is the refrigerator control dialed set to correct
location?
Is the refrigerator placed in direct sunlight or
closely a heat source?
Is the door closed completely? Close the door completely.
Is the door opened too frequently or too long? Open the door less often,
Does the door gasket seal properly? Make the gasket sealing properly.
Is the refrigerator overloaded? Load less food into it.
Is the refrigerator control dialed set to correct
location?
Is the ambient temperature too low?
Hot-pipe is installed in two sides of
refrigerator.That makes refrigerator's
Condensation can occur when you leave the
door open for a long time.
Put on the home circuit breaker or change
the new fuse.
Set the temperature control knob at "4".
Set it to a colder temperature.
Move the refrigerator to proper location.
Set it to a warmer temperature.
Normal state.
Normal state.
5 Vibrations The refrigerator is not level and firm. Place the refrigerator in a level location.
The refrigerator is
6
noisy.
7
properly.
The lamp does not
8
work.
Water bubbling comes from the refrigerant
circulating of the refrigerator.
Contraction and expansion of the insulation
inside the walls may cause popping and
Is the refrigerator unstable or touching the
wall?
Is the refrigerator not level? Adjust the refrigerator leveling.
Were the doors not properly installed? Assure the doors installed propertly.
Is the door gasket dirty and distortion? Cleaning and flatting the door gasket.
Has the home circuit breaker or fuse tripped?
Is the refrigerator's door close completely? Assure the door close completely.
Is the ambient temperature too high?
Is the temperature controller in freezer
chamber or in refrigerator chamber is set at
Normal state.
Normal state.
Keep the refrigerator leaving the wall.
Put on the home circuit breaker or change
the new fuse.
Sets it at a right position.
Operating for all long
9
time.
Too much food is loaded into the refrigerator
and insufficient spaces for airflow.
The door were not closed completely or the
gasket not sealing enough.
Open the door too frequently. Decrease the open-door times.
Load less food into the refrigerator.
Close the doors completely or make the
gasket sealing enough.
Loading...