Leixen VV898 User Manual

Notice

Please use the radio according to the requirement of local regulatory agencies.

To User

Thank you for using LEIXEN Mobile transceiver. We trust our product will give you a convenient and steady communication. Hope you would like the great functions with this radio.

Contents

Security Information 1

Accessories&Options 2

SuppliedAccessories 2 OptionalAccessories 2

Installation 3

Connect Power 3 Radiating of Radio 3 Install with Bracket. 4 Connect Accessories 4

Getting Acquainted 5

LCD Display 8

Basic Operation 10

Power onloff l0 Turn Volume 10 Choose Channel

Transmitting and receiving 11

Function Menu Operation 12

Auto Power Off(APO) 12 APRO (APRO) 12

Busy Channel Lock CBCLock) 12

Key Beep (Beep) 13 Channel Save (CHASave) 13 DTMF Function 13 Dual Waiting (DW) 17 Decode Type and Decode Code 17 Encode Type and Encode Code 20

FM Function (FM) 20 Font size Choose (Font) 22 Key Lock Function CKeylock) 23 Keypad Function CKeypad) 23 Backlight (Lamp) 24 Alias Set Function (Name) 24 Open Display Set (OpenDIS) 25 Custom Keys Set (P1-P3, MKey) 25

High/Low Power Set (Power) 27 PTT ID (PTT ID) 27 ROGER (ROGER) 29 REVERSE (REVERSE) 30 Beat Frequency (RPT SET/RPT TYPE) 30 Save Battery CSavelsat) 31 Scan (SCAN) 31 Squelch Level (SQU 34

III

Step (Step) 34 TailElimination (Tail) 34 TalkAround (Talk) 35 Time out timer (TOT) 35 TX Stop (TXStop) 35 VOX (VOX) 36 Wide and Narrow Band Set (WidNar) 37

User-defined Keys Menu 37

Close (OFF) 37

FM (FM) 38

Band change (Bandchange) 38

Time of system (Time) 38

Monitor Momentary (MONO 38

Monitor Lock (MOLO) 39

SQ OFF Momentary (SQM) 39

Mute (MUTE) 39

Scan (SCAN) 40

High/Low Power (LOW) 40

Emergency (EMG) 40

V!M Mode Switch (V

!M)

.40 DTMF Function (DTMF) 40 Call (Call) .41

Transmit 1750Hz Cl750Hz) .41 AIB Mode Switch (AIB) .41 Talk Around (Talk) .41 Reverse Frequency (Reverse) .41

Reset Menu 42

All Reset 42 Function Reset 42

Programming Operation 43

Lease Function 43 Wireless Change Frequency 44 RX Inhibit/RXTX Inhibit .46 Times ofTX per Minutes Set .47

Maintenance 48

Base Knowledge 48 Maintain and Clean .48

Specification 50

Security Information

To using the radio safety and efficient, Please read the following safety information.

~ Refer service to qualified technicians only. ~ Turn off the radio while taking on fuel or while

parked in a gasoline service station.

~ Please turn off the radio in a flammable,

explosive atmosphere.

~ Do not place the radio in the range of the air bag

spread.

~ Do not expose the radio to long periods of direct

sunlight, nor place it close to heating appliances.

~ Don't keep the radio transmitting too long. It

may be too hot to hurt body or damage the radio

itself.

~ Do not use the radio with a damage antenna, it

might be too hot to hurt body or damage the radio itself.

~ When using this radio, Please make sure the

antenna is connected, or it might make power tube of the radio burned.

~ Please keep at least a distance of 5cm away from

body when you press the PTT.

~ Turn off the power immediately if the radio

diffuses peculiar smells or smoke, and contact the nearest authorized dealer.

Accessories

Options

Welcome to use

LelxeN

mobile transceiver, please check the packaging, make sure the following table accessories are complete, if you find any loss or damage with the packing, please contact your dealer immediately.

Supplied Accessories

Item Qty

Mobile transceiver

DC Power Cable

Bracket

Bracket Screw

CLock in two side of the radio)

User Manual 1

Optional Accessories

USB Programming

DCIAC Adaptor

Cable

DTMFKeypad No Keypad

Microphone Microphone

Antenna Sucker Antenna

Installation

Connect Power

This radio should be connected to 13.8V DC power supply. It can not be connected directly to AC outlet. Connect the radio to stabilized power supply with supplied power cable, DC power cable can not be replaced with a thin wire.

Connect DC power cable to DC power supply, red

wire connects positive, black wire connects negative.

Then plug the jack of the power cable into DC power outlet of car.

Note: Make sure to turn off DC power supply and

radio before connect. DC power supply is connected to the vehicle platform, be sure to turn off DC power supply and drive units. The DC power can only be connected to AC power outlet after all connections are completed.

Radiating of Radio

Heat radiation of mobile transceiver is a very important problem. Heat radiation of this radio takes advantage of the air by using a bracket to install. If the

radio installed in an airtight place, it will affect the

radio cooling. Poor cooling may cause damage to the radio. Do not place books or other equipment on the radio, so as not to obstruct the air flow. The distance between the radio and the wall of car maintain a minimum interval of 10 cm space.

Install with Bracket

An adjustable angle bracket is supplied with the radio. Please fix the bracket on car, demount the two screws beside the radio and lock them again through the hole of bracket. Note: Do not place the transceiver in the range of an airbag deployment may be involved Do not place the radio in the front windshield of car, the heat of sun may cause damage to the radio.

Connect Accessories

Hand Microphone: Hand microphone connection jack is located in the top right of the front panel of radio. Earphone: Earphone connection jack is located in the right of the rear panel of radio. The internal speaker will not sound when earphone is connected. Antenna: Antenna connection is in the left of the rear panel intercom. Antenna system is composed of an antenna, feeder and ground network components. Only careful consideration of the antenna system and

its installation, can make good use of mobile transceiver. The antenna should be the selection of

quality to ensure good communication results. Don't transmit without connecting antenna, transmitting without connecting antenna, may cause damage to radio.

Getting Acquainted

i--l--

-I--l

IIj

~ ~

(@~

- -

tf@

'- '-

VV -898 Upper Panel

4 5

7 8

11 12 13

VV -898 Front Panel

VV -898 Rear Panel

1,Loudspeaker

2, Indicator Light (Red LeD Display

light, green light)

3, MIC Connector (RJ45)

4,CHA+(Channel Up)

PPPI"'",75

5, CHA-(Channel Donw)

6, LCD display screen

-'-!-'

'~'I:

2-=J{1ml -"-'

s=•••••••

-,c

7,VOL+(Volume Up)

8,VOL-(Volume Down)

!~~

2~'

9, Menu Key

10, PI Key

F~!f~.III.I!J.

EmR

N*(;

(User defined)

I "'11

10 1112

15 116 1'7 1'8

11, P2 Key

12, P3 Key

(User defined)

Icon

Feature

Operation Method

13, C!>Power Switch

14,Antenna Connector

Description

oot»

Memory Channel

000

No.

----

15,Power Connector

Being A Channel

SwitchA/B Key

Being B Channel

Switch A/B Key

Keyboard Lockout

Press M Key for 2 Seconds

1m3

VOX Open

Refer to Menu 45

In VFOIMR mode: Decode

Type

and

Decode Code refer

DeS

DCS Open

to ~enu08 and 09, Encoded Type and Encoded Code refer to

10 and 11

CTOpen

The same as above (DCS)

Beat Frequency

Refer to

and 35

Wireless

Refer to Page 44

Frequency Open

•••

Channel

scan

Refer to Menu 39

disabled

Low Power Refer to Menu 30

III

High Power

Refer to

Indicate

Power strength when transmitting,

grids

for high

•••illlI.lfJ.

power, 5 grids for

----

small

power.

Indicate

signal

strength

when

receiving.

rJili]

Auto Power off Refer to

Menu0I

Reverse

Refer to Menu 33

Frequency

Narrowband

Refer to Menu 50

Dual Reception

Refer to Menu 07

DT~F

Refer to Menu 06

Displayed frequency

value,

channel

names,

••••••• 11

menu items,

and

----

••••••• 11

other

numbers, letters or symbols Information

Basic Operation

Power on/off

Connect the power and press the

button, the radio

turned on, issued a "toot toot" tone. Press the

c.!>

key

for 2 seconds, the radio turned off.

Turn Volume

Press

"VOL+"

to up volume, press

"VOL-"

to down

volume. The volume level range: 0-15. Default: 4.

+ 21 hidden pages

Leixen VV898 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual