Leister Welding-Pen R Operating Instructions Manual

The LEISTER Welding-Pen R is a hot air tool that can be installed for continuous

operation.

It has an ergonomic shape and is light weight what makes it suita

ble as hand tool as

well as for the installation into machines and vent constructions.

The cooled heater tube as well as the LEISTER screw-on drawing nozzle with
taking tip make the Welding Pen to a very efficient tool for plastic welding.

• Welding of thermoplastic materials and also single-ply flexible plastics in the
form of boards, tubes, profiles, foams, tiles and sheets.

•

The following procedures are possible:
Rod and melt welding by means of LEISTER nozzles

• The hot air tool Welding PenR needs an external air-supply
(LEISTER blower or compressed air).

LEISTER Welding-Pen R
Hot air tool

Please read operating instructions carefully
before use and keep for further reference.

GB

OPERATING INSTRUCTIONS

1

APPLICATION

®

LEISTER Process Technologies, Riedstrasse, CH-6060 Sarnen /Switzerland

Tel. [phone] Fax [phone]

www.leister.com [e-mail]

• Digital display of SET and ACTUAL
temperature values

• Temperature steplessly controlled

• Heating element protection

• Adaptor tube with heat protection

Electrical safety: double insulated

-2-

TEST SIGNS

TECHNICAL DATA

Voltage V~ 100 120 230
Frequency Hz 50/60 50/60 50/60
Capacity W 450 600 1000
Temperature °C 20 – 600 20 – 600 20 – 600
Air flow l/min. >40 >40 >40

Air pressure Pa max. 10

5

(dynamic)

Weight g 1000 with 3m cable, air hose and Y-connection
Size mm ø 32/43 × 270

Mains voltage cannot be switched over

This tool is CCA certificated (CENELEC Certification Agreement).

Danger to life when opening the tool, as live components

and connections ar exposed. Unplug the tool before
opening it.

Incorrect use of hot air blowers can cause fire and
explosion hazard, especially near combustible materials
and explosive gases.

The tool must be operated with supervision. Warmth can
reach combustible materials, which are out of sight.

For personal protection on building sites we strongly

recommend the tool be connected to a GFCI (Ground
Fault Circuit Interrupter) or a RCCB (Residual Current
Cir

cuit Breaker) .

The voltage rating stated on the tool must correspond to
the line/mains voltage.

Do not touch the element housing and nozzle when they
are hot as they can cause burns. Let the tool cool down.
Do not point hot air flow in the direction of people or
animals.

Protect tool from damp and wet.

FI

120

230

WARNING

CAUTION

Description of tool

1. Heat protection tube

2. Potentiometer for temperature
adjustment

3. Handle

4. Hose clamp

5. Air hose

6. Y-connection

7. Hose connection for
air-supply G1/4”

8. Cable screw fitting for mains supply
M16 × 1.5

9. Power-supply cord

10. Digital display of SET and ACTUAL
temperature values

11. Screwed nozzle joint

1

3

2

4

5

11

10

5

4

7

6

8

9

-3-

USAGE Welding-Pen R