Leister Diode S, Diode PID Operating Instructions Manual

1

LEISTER Diode S, Diode PID
Hot Air Tool

Please read operating instructions carefully
before use and keep for further reference.

• The LEISTER Hot Air Pistol Diode S, Diode PID is designed for continuous
operation and is suitable as a hand tool or for building into machines, instal­lations and appliances

• Welding of thermoplastic materials and also single-ply flexible plastics and
modified bitumen in the form of boards, tubes, profiles, lining membranes,
coated materials, films, foams, tiles, and sheets. The following procedures
are possible: overlap welding, welding with rod, with tape, butt welding
and melt welding

• Heating-up for forming, bending and sealing of thermoplastic semi-
finished materials and plastic granules

• Drying of water-damp surfaces

• Shrinking of heat-shrink sleeves, films, tapes, solder sleeves and moulded parts.

• Soldering copper pipes, solder joints and metal foils

• Activating/dissolving of solvent free adhesives and fusion adhesives.

• Separating and fusing synthethic fibres and fabrics

• Removing plastic mould flash and putting a shine on plastic surfaces

LEISTER Diode PID

• Temperature electronically
steplessly controlled

• Digital display of SET and
ACTUAL value °C

(in °F on request)

• Air flow monitoring

• Element protection

• Heat protection tube

LEISTER Diode S

• Temperature steplessly
adjustable

• Element protectoion

• Heat protection tube

GB

OPERATING INSTRUCTIONS

APPLICATION

®

LEISTER Process Technologies, Riedstrasse, CH-6060 Sarnen/

Switzerland

Tel. [phone] Fax + 41- 41 662 74 16

www.leister.com [e-mail]

Voltage V~
Capacity W
Frequency Hz
Temperature °C
Air flow l/min.
Air pressure Pa
Weight g
Size mm

42, 100, 120, 230
900, 1350, 1600, 1600
50/60
20 – 600
min. 40
max. 10

5

(

dynamic)
425, 1150 with 3 m cord and 3 m air hose
265 x Ø 40

2

Mains voltage cannot

be switched ove

TEST SIGNS

TECHNICAL DATA

105 Pa = 1 bar

This tool is CCA certificated (CENELEC Certification Agreement).

Electrical safety: double insulated

Danger to life when opening the tool, as live compo-

nents and connections ar exposed. Unplug the tool
before opening it.

Incorrect use of hot air blowers can cause fire and
explosion hazard, especially near combustible materials
and explosive gases.

The tool must be operated with supervision. Warmth
can reach combustible materials, which are out of sight.

For personal protection on building sites we strongly

recommend the tool be connected to a GFCI (Ground
Fault Circuit Interrupter) or a RCCB (Residual Current
Circuit Breaker) .

The voltage rating stated on the tool must correspond to
the line/mains voltage.

Do not touch the element housing and nozzle when
they are hot as they can cause burns. Let the tool cool
down. Do not point hot air flow in the direction of
people or animals.

Protect tool from damp and wet.

FI

120

230

WARNING

CAUTION