Page 1
1
Important Safety
Instructions
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USE-SERVICEABLE PARTS
The lightning flash with arrowhead symbol, within an equilateral triangle, is
intended to alert the user to the presence of uninsulated “dangerous voltage”
within the product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric to persons.
The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OF MOISTURE.
POWER SUPPLY:
Connect the supplied adaptor to the side of the unit in the slot marked “DC 5V IN”. Plug
the two-prong end of the power cord to an AC100-240V outlet. If you have difficulty
inserting the plug, turn it over and reinsert it. If the unit is not used for a long time,
disconnect the plug from the outlet.
NOTE:
Before plugging the power cord into an AC outlet, make sure that all the connections
have been made.
Page 2
2
Important Safety
Instructions
CAUTION: These servicing instructions are for use by qualified service personnel only.
To reduce the risk of electric shock, do not perform any servicing other than that
contained in the operating instructions unless you are qualified to do so.
Refer to service manual for servicing instructions. To reduce the risk of fire or electric
shock, do not expose this apparatus to rain or moisture.
NOTES
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with a damp cloth.
7) Do not block any of the ventilation openings. Install in accordance with the
manufacturer's instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide blade or the third prong is
provided for your safety. When the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with a cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use
caution when moving the cart/apparatus combination to avoid injury
from tip-over.
Page 3
3
Important Safety
Instructions
13) Unplug this apparatus during lightning storms or when unused for long periods of
time.
14) Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
15) Apparatus shall not be exposed to dripping or splashing and no objects filled with
liquids, such as vases, shall be placed on the apparatus.
To prevent the GPS from being damaged, be sure to keep the GPS out of direct
sunlight or heat.
Warning
Failure to avoid the following potentially hazardous situations may result in injury or
property damage.
The unit is designed to provide you with route suggestions. It does not reflect road
closures or road conditions, traffic congestion, weather conditions, or other factors that
may affect safety or timing while driving.
Use the unit only as a navigational aid. Do not attempt to use the unit for any purpose
requiring precise measurement of direction, distance, location, or topography. This
product should not be used to determine ground proximity for aircraft navigation.
CAUTION:
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
The batteries (or batteries installed) shall not be exposed to excessive heat such as
sunshine, fire or the like.
Underwriters Laboratories Inc. (“UL”) has not tested the performance or reliability of the
Global Positioning System (“GPS”) hardware, operating software or other aspects of this
product. UL has only tested for fire, shock or casualty hazards as outlined in UL’s
Standard(s) for Safety [Note-Consider referencing specific UL standard].
UL Certification does not cover the performance or reliability of the GPS hardware and
GPS operating software.
Page 4
4
Important Safety
Instructions
UL MAKES NO REPRESENTATIONS, WARRANTIES OR CERTIFICATIONS
WHATSOEVER REGARDING THE PERFORMANCE OR RELIABILITY OF ANY GPS
RELATED FUNCTIONS OF THIS PRODUCT.
Notice for the USA FCC Part 15:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference
that my cause undesired operation.
CAUTION: To comply with the limits of the Class B digital device, pursuant to Part 15 of
the FCC Rules, this device is comply with Class B limits. All peripherals must be shielded
and grounded. Operation with non-certified peripherals or non-shielded cables may
results in interference to radio or reception.
Page 5
5
Important Safety
Instructions
MODIFICATION: Any changes or modifications not expressly approved by the grantee of
this device could void the user’s authority to operate the device.
The images in this manual are for reference only and they may appear
different from the actual items.
Page 6
6
ITEM
NAME
QTY
Car Adaptor
1
Mounting Bracket
1
Mounting Cradle
1
Stylus
1
USB Cable
1
User’s Manual
1
Accessories List
The following items are included with your GPS unit.
NOTE
Accessories and their parts numbers are subject to modification without prior notice due
to improvements.
Page 7
7
Contents
Important Safety Instructions
Accessories
System Connections
View of Main Unit
Power supply Preparation
Use of the Mount Accessories
Troubleshooting
Specifications
…………………………………..……..…..1
……………………………….……….…....5
……………………………….………..…...7
………………………………..…………....9
……………………………….…….….…10
…………………………….…….….…….11
……………………………….……….…..12
…………………………….……………...14
Page 8
8
View of Main Unit
1. LCD Screen
Finger touches the screen directly or use the stylus included for optional.
2. Charge Indicator
When charging the battery, it is red. When the battery is fully charged, it turns
green.
3. POWER Button
Press for a longer time to enter or exit the standby mode.
4. ON/OFF Switch
Used to switch power on or off.
5. Card Slot
Insert the SD card into the slot.
6. Earphone Jack
Connect earphone for private listening. When the earphone is connected to this
jack, the speaker will be turned off automatically.
7. USB Charging Port
Connect to the supplied car adapter to charge the unit.
Connect to the USB devices.
Page 9
9
View of Main Unit
8. Speaker
NOTE: In order to acquire good GPS signals, make sure the area with built in GPS
Antenna of the unit is not obstructed by something(such as heat insulation paper)
and has a clear view of the sky. And you’d better to position the unit with its GPS
antenna area slightly upward inclinded.
Page 10
10
System Connections
Always ensure that the unit and any other external device connected to the unit are
switched off and unplugged from the power supply before you attempt to connect
the unit to any external device.
Inserting SD Card
The unit is designed with SD Card slot which allows you to insert the SD card into the
unit as shown below:
To remove the card, gently press the card in with your fingernail. The card unlocks and
protrudes slightly. You can now remove the card.
Connecting to Earphones
Connect the earphones to the right side of the unit for private listening.
When earphone is connected, the speakers will automatically turn off.
Note: Overly loud volume could damage your hearing. So turn down the volume before
you connect the earphones, and then raise the volume to comfortable level.
Page 11
11
Power Supply
Preparation
Using the Car Adaptor
The unit is supplied with a Car Adaptor for powering while in a vehicle.
Connect the Car Adaptor Power Plug to the unit’s USB charging port and plug the other
end to the vehicle’s 12-24V accessory cigarette socket, as shown below.
Attention:
Place the unit in a proper position for viewing.
Disconnect the unit from the Car Adaptor when starting the vehicle.
When connected with adaptor, the LCD screen will be brighter than when it's not
charging.
About the battery
Your portable GPS device comes with a built-in rechargeable battery. Charge the battery
fully before initial use. Charging time is normally about 3 hours. A fully charged battery
delivers about 2 hours of use.
Working conditions and precautions for the rechargeable battery
Battery should only be used and charged when temperatures are between
32-100F.
Maintain well-ventilated conditions around the product to avoid overheating. Don’t
put the product on a bed, sofa or anything that may block ventilation to the product.
When the battery is weak, an indication symbol will appear on the LCD screen and
the unit will power off automatically after a while.
Page 12
12
Use of the Mounting
Accessories
When using the unit in vehicle, you can use the supplied mount accessories (mount
bracket and mount cradle) to mount the unit in the vehicle. Take the following steps to
operate:
1. See Fig. 1, slide the mount cradle onto the end of the mount bracket to fix it.
2. See Fig. 2. Set the bottom edge of the unit onto the mount cradle. Then push the
tap at the top of the mount cradle in arrow 1 direction to mount the unit to the mount
cradle. To remove the unit, push the tap at the top of the mount cradle in arrow 1
opposite direction.
3. Lift the suction cup lever and then press the suction cup to the windshield. Then
press down the suction cup lever in arrow 2 direction to fix the bracket to the
windshield. At the end, rotate the knob to adjust the unit to proper position.
Warning:
The device must not be mounted so that it impairs the driver’s view of the road. Please
take extra precaution to ensure the airbags are not obstructed by the device.
Page 13
13
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Users can’t turn
the unit on.
The adaptor doesn’t
connect well.
Connect the adaptor
correctly.
The built-in rechargeable
battery is weak.
Use the adaptor to supply
power or charge the
battery.
Unit will not
activate after
pressing and
holding the stand
by button when
connected to the
adaptor for
charging.
The unit had not been
used for a long time and
built-in battery was overly
discharged
Press Reset to turn the
unit on.
There is no sound.
The volume may be turned
down or mute.
Turn up the volume or
turn on the sound output.
Dark screen.
The brightness may be
turned down.
Adjust the brightness of
the LCD.
The unit can’t
receive satellite
signals or can’t
orient.
The unit may be
obstructed by buildings or
metal block.
Make sure to use the unit
out of room.
Troubleshooting
Take steps described in the tables below to solve simple problems before contacting
customer service.
If you suspect something wrong with this unit, immediately turn the power off and
disconnect the power connector from the unit. Never try to repair the unit yourself
because it is dangerous to do so.
Page 14
14
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
The unit can
receive signals
now but can’t then
or signals received
are not stable.
The built-in rechargeable
battery is weak.
Use the adaptor to supply
power or charge the
battery.
The unit may be
obstructed by veil, such as
heat insulation paper.
Remove the veil.
Swing of the unit is too
great.
Avoid great swing of the
unit.
System software of the
unit fails to function after a
change.
Turn the unit on again.
Troubleshooting
Other possibilities:
Static or other external interference may cause the unit to function abnormally. In order to
recover normal status, please unplug the power supply cord and then plug it into the
outlet again to reset the unit. If the problems still exist, please cut off the power supply
and consult your service center or a qualified technician.
Page 15
15
TFT screen size
4.3 inches
Frequency Response
20Hz - 20kHz
Audio Signal-to-noise Rate
≥65dB
Audio distortion+noise
≤-20dB (1kHz)
Channel Separation
≥70dB (1kHz)
Dynamic Range
≥80dB (1kHz)
Power
DC 5V
Power Consumption
< 8W
Dimensions
118mmX78mmX16mm (L*W*D)
Weight
About 0.16Kg
Specifications
Design and specifications are subject to change without notice.
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exit. Check with your Local Authority or
retailer for recycling advice. (Waste Electrical and Electronic Equipment
Directive)
Loading...