LEGRAND Solarfective SF-T4 Installation Instructions Manual

Solarfective

Televent

®

No: D000047 – 11/19 rev. 1

Installation Instructions

Catalog Numbers • Les Numéros de Catalogue • Los Números de Catálogo: SF-T4

Country of Origin: Made in Canada • Pays d’origine: Fabriqué en Canada • País de origen: Hecho en Canadá

DESCRIPTION AND OPERATION

The Televent Shade system is a unitized shade cassette system designed to form a vented pocket
above the ceiling. The Televent system may be either motorized or manual, and is available with the
full range of fabrics and accessories from the Solarfective collection.

CAUTION – Be sure to follow all appropriate safety guidelines, including the use of safety glasses
and ensure to keep the shade fabric clean by using clean gloves whenever touching it.

Tools Required for Installation:

• Flathead Screwdriver

• Suitable #8 Pan Head Screws
(4 per shade)

• Safety Glasses

• Gloves

Step 1 Attach Televent Hoods

Attach each Televent Hood with appropriate
fasteners with the bottom edge at the same
height as the bottom of the drop ceiling.
Ensure the middle of hood is even with the
middle of the mullion.

Ceiling line
on wall above
window

Leave spreader in the
hood during installation
to avoid compression
during ceiling installation.

INSTALLATION

Step 2 Attach Ceiling T-Bar

Screw T-Bar to Televent Hood as
shown.

Step 3 Install Ceiling Tiles

NOTE: Coordinate installation with the

ceiling contractor to ensure ceiling
is installed level prior to attaching
shade hoods.

Bring ceiling tile to T-Bar as shown. The
Televent Hood cannot support any ceiling
weight. Ensure that all ceiling materials are
properly secured with their own support
system, as using the shading as support will

cause mounting system failure.

Step 4 Position Televent Shade

On the Televent unit, push the spring clip out about ½”
before installing the shade, so it will snap into place.

Step 5 Install the Televent Shade

Push the shade up into the hood until a distinct click
is heard. It is the spring clip snapping into place.

Bend clip out

2