Legrand Evolution Series Work Surface Portal User Manual

Evolution Series

Legrand/Wiremold electrical systems conform to and should be properly grounded in compliance with requirements of the current National Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire hazard if improperly installed or used. Legrand/Wiremold electrical products may bear the mark of a Nationally Recognized Testing Laboratory (NRTL) and should be installed in conformance with current local and/or the National Electrical Code.

™

Work Surface Portal

I N S T A L L A T I O N I N S T R U C T I O N S

Installation Instruction No.: 1 008 956 – December 2009

roducts: WS6F, WS6S, WS8F, WS8S

CAUTION: The 3-prong, grounding type plugs in all units are for use with 3-prong, grounded receptacles only.

SURFACE INSTALLATION:

Step 1. Using a jigsaw and the template provided, cut a

Modifying or bypassing the ground pin for use in a non-grounded receptacle may lead to electrical shock, and voids the product warranty. All units are designed for interior use in dry locations only.

circular opening in the table. WS6S – 6 1/4" [159mm] diameter WS8S – 8 1/4" [210mm] diameter

IMPORTANT: Please read all instructions

before beginning.

Step 2. Insert Evolution Series Work Surface Portal into

opening in the table, and orient as desired.

FLUSH INSTALLATION:

Step 1. Using a router with a 1/2" [12.7mm] straight cutting bit

and a circle cutting jig, rout a circular pocket based on the dimensions shown below.

WSF6

WSF8

6 1/4"

[159mm]

7 1/4"

[184mm]

8 1/4"

[210mm]

9 1/4"

[235mm]

5/32"

[4.0mm]

5/32"

FLUSH INSTALLATION (continued):

Step 2. Using a jigsaw, cut along the inside edge of the

routed recess to remove the center.

MOUNTING & WIRING (Flush & Surface Models):

Step 1. Insert mounting clip into slot that is appropriate for

the table thickness, and tighten thumb screw. Accommodates table thicknesses between 3/4" [19mm] and 3 1/4" [82mm].

Step 3. Insert Evolution Series Work Surface Portal into

opening in the table, and orient as desired.

Step 2. Install Extron Electronics MAAP devices (Not

provided) using screws provided with the devices.

Step 3. Make wiring connections to AV devices and data

connectors. Utilize the slots on the underside of the Evolution Series Work Surface Portal to provide strain relief for the cables.

Step 4. If additional protection for the work surface is

desired, apply adhesive-backed bumper to cover in location indicated.

+ 2 hidden pages