Swifts® cable ladder ancillary items
Nylon pad
Ø15 nylon bush
Nylon washer
Hold down clip
Hold down clip
One hole
Ø11
3
40
65
15
M10 x 40 long
grade A4-70
stainless steel
setscrew
M10 grade A4
stainless steel
form A washer
Nylon 66
insulating pad
M10 nylon 66
bush 7·5 long
M10 nylon 66
washer
Stainless steel
hold down clip
M10 grade A4
stainless steel
nut
M10 grade A4
stainless steel
spring washer
M10 grade A4
stainless steel
form A washer
W
X
hold down clips and insulated hold down clips
150125100
Hold down clips are used for fixing cable ladder to trapeze hangers,
Swiftrack channel or other flat support surfaces. They are fitted on the
outside of the ladder rail
Supplied singly without fasteners
Supplied with the required nylon insulating pad, bush and washer
Insulated versions for stainless steel ladder are available on request,
for details contact us on +44 (0) 845 605 4333
Ladder range Cat. Nos.
Topaz Sapphire Emerald
Standard hold down clip ZFF PFF EFF
Insulated hold down clip ZF INF PF INF EF INF
■ Installation (typical)
Standard hold down clip
Insulated hold down clip
■ Assembly
Insulated hold down clips are assembled as shown (typical) with the
nylon pad, bush and washer providing the required insulation
Standard hold down clips are assembled in the same way, but without
the insulating parts (bold type – see below)
Use M10 screw, nut and washers to suit the application (not included)
Use fasteners illustrated – only those shown in bold type are included
■ Assembly (continued)
Standard hold down clip
Insulated hold down clip
■ Dimensions and weights
Weight
Cat. Nos. (kg)
ZFF 0·069
PFF 0·069
EFF 0·069
Weights
All weights given are in kilograms (kg) and are for hot dip
galvanised G finish
To obtain the appropriate component weight in other
finishes, multiply the given weight by the following factors :
Deep galvanised (D) x 1·07
Stainless steel (S) x 0·94
Powder coated (E) x 0·97
Fixing hold down clips to supports
All types of support from the Swifts range are provided with correctly
positioned fixing holes to accept hold down clips without drilling. The
table contains data on fixing hole spacing required when attaching
hold down clips to other supports
W = ladder width
80
Centre distance
Cat. Nos. between fixing holes
x
ZFF W + 95
PFF W + 95
EFF W + 95
Key : Replace the letter shown in red with your choice from the
following options :
F = Finish : G (hot dip galvanised after manufacture)
D (deep galvanised)
S (stainless steel)
E (powder coated)
All dimensions (mm) are nominal
Trapeze hangers : see p. 75
➔
Swiftrack channel support : see p. 99-108
➔
Loading...