Leggett & Platt Prodigy Service Manual
PRODIGY
TANDEM SETUP
(split base synchronization)
STEP 1
™
Prodigy
™
STEP 2
POWER
DOWN BOX
(connected
to Base 2)
BASE 2
BASE 1
Position both bed bases side-by-side.
Note: Make sure batteries are installed in (1) remote control.
PRESS IN (SLIGHTLY) AND
PUSH DOWN TO REMOVE
BATTERY COMPARTMENT DOOR
J BOX
Plug both bed bases into a
working electrical outlet.
Note that the status lights
on both power down boxes
are green, indicating power
down boxes are set to
“primary.”
STEP 3
RESET
BUTTON
Locate the power down box connected to Base 2.
STEP 4
POWER DOWN
BOX - BASE 1
LEARN
BUTTON
STATUS
LIGHT
POWER DOWN
BOX - BASE 2
Remove the battery compartment door, then remove the batteries
(if installed).
STEP 5
POWER DOWN
BOX - BASE 2
POWER DOWN
BOX - BASE 1
STATUS
LIGHT
LEARN
BUTTON
Press and hold the reset button (located inside the battery
compartment) until both the status light and learn light on the
power down box flash red.
“Lrn” BACKLIGHT
DISPLAY
POSITION 1
BUTTON
WAVE UP
BUTTON
Locate the power down box for Base 1, then press and hold the
learn button until the learn light flashes red. NOTE: Status light on
Base 1 power down box is green and Base 2 power down box is now
yellow.
STEP 6
LEARN
LIGHT
POWER DOWN
BOX - BASE 1
Next, on Base 2, press and hold the learn button on the power
down box until the learn light flashes red.
POWER DOWN
BOX - BASE 2
LEARN
BUTTON
Press and hold the Base 1 power down box learn button (again)
until the status light flashes red.
“Lrn” BACKLIGHT
DISPLAY
POSITION 1
BUTTON
WAVE UP
BUTTON
When the status light for Base 2 begins flashing rapidly,
simultaneously press and hold the Position 1 and Wave Up
buttons on remote control 1. Note: “Lrn” will appear in the
backlight display when buttons are pressed simultaneously.
Continue to hold the buttons until the backlight on the remote
control begins flashing, then release. The remote control is now
programmed to operate Base 2.
While the learn light for Base 1 is flashing rapidly, simultaneously
press and hold the Position 1 and Wave Up buttons on remote
control 1. Note: “Lrn” will appear in the backlight display when
buttons are pressed simultaneously. Continue to hold the buttons
until the backlight on the remote control begins flashing, then
release. The remote control is now programmed to operate Base 1.
One remote control is now programmed to operate two bases. Press
any adjustment button on the remote control to verify both bases
operate simultaneously. Note: If programming procedure fails, go back
to Step 2 and initiate the programming procedure a second time.
Reinstall batteries into power down box, if applicable. Install king
size mattress to complete setup.
To program 2nd remote control to operate both bases,
repeat Steps 5 & 6 with 2nd remote control.
[adjustable bases]
NATIONWIDE CUSTOMER SERVICE
toll free: (800) 888-3078
e-mail: accustomerservice@leggett.com
99301292 EDR11906 2/12
© 2012 Leggett & Platt Adjustable Bed Group, a division of Leggett & Platt, Incorporated
Loading...