If adjustable base does not operate or if parts are missing, call:
800-888-3078
Do not contact retail store or dealer.
ADVISORY
IMPORTANT INFORMATION
READ THE FOLLOWING INFORMATION CAREFULLY BEFORE USING THIS PRODUCT
PRODUCT RATINGS
The base lift motors are not designed for
FOR OPTIMUM ADJUSTABLE BASE
OPERATION, USE A GROUNDED,
ELECTRICAL SURGE PROTECTION DEVICE
(NOT INCLUDED). FAILURE TO USE A
SURGE PROTECTION DEVICE COULD
COMPROMISE SAFETY OR CAUSE PRODUCT
MALFUNCTION.
ELECTRICAL RATING
Electrical components are rated for 100–240V,
50–60Hz, 1.5 amp.
continuous use. Reliable operation and full
life expectancy will be realized as long as the
lift motors do not operate any more than four
(4) minutes over a forty (40) minute period,
or approximately 10% duty cycle. Note:
Massage equipped bases are not designed
for continuous, extended massage operation.
Massage systems are rated for a maximum
of 2 hours of use within any 6 hour period.
Any attempt to circumvent or exceed product
ratings will shorten the life expectancy of the
product and may void the warranty.
ELECTRICAL GROUNDING
This product is equipped with a polarized or
grounded electrical power cord. The power cord
will only fit into a grounded, electrical surge
protection device (not included) or a grounded
electrical outlet.
WARRANTY WARNING
Do not open any control boxes, motors or
remote control devices (with the exception of
the remote control and power down box battery
compartments). The product warranty will be
void if these components are tampered with.
Do not attempt to alter component wiring or
adjust or modify the structure of the product in
any way or the warranty will be void. Any repair
or replacement of bed parts must be performed
by authorized personnel.
LUBRICATION
This product is designed to be maintenance
free. The lift motors are permanently lubricated
and sealed—no additional lubrication is
required. Do not apply lubricant to lift motor
lead screws or any nylon nuts or the base may
inadvertently creep downward from the elevated
position.
The recommended weight restrictions for
Prodigy™ bases is 600 lb (272 kg). The base
will structurally support the recommended
weight distributed evenly across the head and
foot sections. This product is not designed
to support or lift this amount in the head
or foot sections alone. Note: Exceeding the
recommended weight restrictions could damage
the base and void the warranty.
For best performance, consumers should enter
and exit the adjustable base with the base in
the flat (horizontal) position.
THE HEAD OR FOOT SECTIONS WHILE IN THE
RAISED POSITION.
DO NOT SIT ON
UL (Underwriters Laboratories) recognized
components.
CFR 1633 approved for use with most
mattresses.
Assembled in USA.
Prodigy™ Owners Manual 99301078-k
3
ADVISORY
IMPORTANT INFORMATION
READ THE FOLLOWING INFORMATION CAREFULLY BEFORE USING THIS PRODUCT
SMALL CHILDREN / PETS WARNING
After the base is unboxed, immediately dispose
of packaging material as it can smother small
children and pets. To avoid injury, children or
pets should not be allowed to play under or on
the base. Children should not operate this base
without adult supervision.
HOSPITAL USE DISCLAIMERThis base is designed for in-home use only. It
is not approved for hospital use and does not
comply with hospital standards. Do not use this
base with tent type oxygen therapy equipment,
or use near explosive gases.
PACEMAKER WARNING
This product produces a vibrating sensation.
It is possible that individuals with heart-assist
pacemakers may experience a sensation similar
to exercise. Consult physician for complete
information.
SERVICE REQUIREMENTS
Service technicians are not responsible for
moving furniture, removing headboards and
footboards or any items required to perform
maintenance on the base. In the event the
technician is unable to perform service due
to lack of accessibility, the service call will
be billed to the purchaser and the service will
have to be rescheduled.
FCC COMPLIANCE
Components meet Class B digital device
rating (Part 15, FCC rules) for residential use.
Prodigy™ bases generate, use and may radiate
radio frequency energy. Radio communication
may be affected if not installed and operated
as recommended in this manual. Changes or
modifications not expressively approved by the
party responsible for compliance could void the
user’s authority to operate the equipment.
Radio frequency = 2.4GHz.
LOCKING CASTER SAFETY FEATURE
Prodigy™ bases are equipped with locking
casters to prohibit the base from movement.
For best results, place rubber caster cups under
locking casters when the base is located on
smooth or hard surface flooring—it is possible
for locking caster equipped bases to slide
without the use of rubber caster cups.
To activate locking casters, push down on the
lock tab. To disengage the locking mechanism,
push up on the lock tab (see illustration below).
LOCKING CASTER
DETAIL
Prodigy™ Owners Manual 99301078-k
4
LOCK
ACOUSTICS
LIFTING/LOWERING MECHANISMS
The lift/lower feature will emit a minimal
humming sound during operation. This is
normal.
During operation, the lift arm wheels make
contact with the platform support of the base.
This applies slight tension on the moving
components and resonance is reduced to a
minimum level. If excessive noise or vibration
is experienced, reverse the movement
action (up or down) of the base with the
remote control. This should realign the
base’s activating mechanisms to the proper
operational position.
MASSAGE OPERATION
The massage feature will emit a minimal tone
during operation. This is normal. When the
massage level is increased, motor resonance
will intensify accordingly.
LOCATION ENVIRONMENT
The level of sound experienced during
operation is directly related to the location
environment. For example, when a base is
located on a hardwood floor with the massage
feature in operation, a vibrating tone will be
audible. To minimize this resonance, place
a piece of carpet—or optional rubber caster
cups—under each leg or caster of the base.
See the Accessories section of this manual for
rubber caster cup order information.
It is possible to experience vibration or noise
from the headboard brackets, headboards or
footboards if mounting bolts are not firmly
tightened.
Prodigy™ Owners Manual 99301078-k
5
INSTALLATION
For installation and setup, complete the numbered procedure indicated below and on the
following pages:
STEP 1
Before discarding any packing materials,
check the adjustable base shipping carton
and verify the following items are
included:
• (1) Foot Mattress Retainer
(per base)
• (4) 4 inch Bed Legs*
• (4) Locking Leg Casters
• (2) Headboard Bracket Assemblies**
• (1) Headboard Bracket Hardware Kit
**
card)
(blister
• (1) Remote Control
• (1) Owners Manual
• (1) Warranty Activation Card
*4 inch legs may be used separately or in combination with
casters to raise base to varying heights off the floor:
• 4 inch leg only = 4 inch base height
• 4 inch leg w/caster = 6-1/2 inch base height
**Some Prodigy™ models may not include headboard
brackets.
LOCKING
LEG CASTER
(4 pieces)
FOOT
MATTRESS
RETAINER
(1 per base)
4” LEG
(4 pieces)
4” legs standard with product. Other
legs may be included based on provider’s
discretion. If different leg height is
desired, please refer to Accessories page
in this manual for purchase options.
ANGLE BRACE
HEADBOARD BRACKET ASSEMBLIES
Queen size shown—twin size (or smaller)
headboard brackets are not equipped with angle
brace. (4 pieces, 2 assemblies)
Prodigy™ Owners Manual 99301078-k
6
REMOTE
CONTROL
HEADBOARD BRACKET
HARDWARE KIT
(hardware blister card: 16 pieces)
INSTALLATION
STEP 2
Carefully lift the base frame from the shipping carton, keeping the unit
top-side-down.
STEP 3
Install (4) legs into the base frame. Simply screw each leg into a tapped
hole at each corner of the base frame (FIGURE 1). Insert casters into the
bottom of each base leg.
CASTERS – PRESS-FIT
INTO BOTTOM OF LEGS
LEGS – SCREW INTO
TAPPED HOLE AT
EACH CORNER
FIGURE 1: Leg and caster installation.
STEP 4
Remove and extend out power cord from the protective packaging.
POWER CORDS MUST NOT INTERFERE WITH
ANY ADJUSTABLE BASEMECHANISMS.
Prodigy™ Owners Manual 99301078-k
7
Loading...
+ 15 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.