Leggett & Platt Designer Series Owner's Manual

[
adjustable bases
]
adjustablebases.com
© 2012 Leggett & Platt Adjustable Bed Group, a division of Leggett & Platt, Incorporated
MADE IN THE USA NATIONWIDE CUSTOMER SERVICE
toll free: (800) 888-3078
Designer Series™ 99301294
26
Repairs to or replacement of an adjustable base or its components under the terms of this limited warranty will apply to the original warranty period and will not serve to extend such period.
The decision to repair or to replace defective parts under this warranty shall be made, or cause to be made, by L&P at its option and in its sole discretion.
Repair or replacement shall be the sole remedy of the purchaser. There shall be no liability on the part of L&P for any special, indirect, incidental, or consequential damages or for any other damage, claim, or loss not expressly covered by the terms of this warranty.
This limited warranty does not include reimbursement for inconvenience, removal, installation, setup time, loss of use, shipping, or any other costs or expenses. Leggett & Platt or its service technicians shall not be responsible for moving furniture or any other items not attached to the adjustable base in order to perform service on the adjustable base.
It is the sole responsibility of the purchaser to provide adequate space and accessibility to the adjustable base. In the event that the technician is unable to perform service due to lack of accessibility, the service call will be billed to the purchaser and the service will have to be rescheduled.
L&P makes no other warranty whatsoever, express or implied, and all implied warranties of merchantability and fi tness for a particular purpose are disclaimed by L&P and excluded from this agreement.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to every purchaser.
This warranty gives the purchaser specifi c legal rights, and the purchaser may also have other rights, which may vary from state to state. This warranty is valid in all 50 states, Puerto Rico, and Canada.
1-5-LIFETIME WARRANTY
WARRANTY INFORMATION
PO Box 668
Lexington, NC 27293
800-888-3078
For customer service online, email:
accustomerservice@leggett.com
Please do not contact retail dealer or any other service personnel.
Designer Series™ 99301294
4
IMPORTANT INFORMATION
READ THE FOLLOWING INFORMATION CAREFULLY BEFORE USING THIS PRODUCT
ELECTRICAL RATING
Electrical components are rated for 110/120 voltage, 60Hz, 3.9 amp.
ELECTRICAL GROUNDING
This product is equipped with a polarized or grounded electrical power cord. The power cord will only fi t into a grounded, electrical surge protection device (not included) or a grounded electrical outlet.
WARRANTY WARNING
Do not open any control boxes, motors or remote control devices (with the exception of the remote control and power down box battery compartments). The product warranty will be void if these components are tampered with. Do not attempt to alter component wiring or adjust or modify the structure of the product in any way or the warranty will be void. Any repair or replacement of base parts must be performed by authorized personnel.
LUBRICATION
This product is designed to be maintenance free. The lift motors are permanently lubricated and sealed—no additional lubrication is required. Do not apply lubricant to lift motor lead screws or any nylon nuts or the bed may inadvertently creep downward from the elevated position.
PRODUCT RATINGS
The base lift motors are not designed for continuous use. Reliable operation and full life expectancy will be realized as long as the lift motor operation does not exceed fi ve (5) minutes over a thirty (30) minute period, or approximately 16% duty cycle. Note:
massage equipped bases are not designed for continuous, extended massage operation. Massage systems are rated for a maximum of 2 hours of use within any 6 hour period.
Any attempt to circumvent or exceed product ratings will shorten the life expectancy of the product and may void the warranty.
The recommended weight restrictions for this adjustable base is 600 lb (272 kg), all sizes. The base will structurally support the recommended weight distributed evenly across the head and foot sections. This product is not designed to support or lift this amount in the head or foot sections alone. Note: exceeding
the recommended weight restrictions could damage the base and void the warranty.
For best performance, consumers should enter and exit the adjustable base with the base in the fl at (horizontal) position.
DO NOT SIT ON THE HEAD OR FOOT SECTIONS WHILE IN THE RAISED POSITION.
UL (Underwriters Laboratories) recognized components. CFR 1633 approved for use with most mattresses. Made in USA.
ADVISORY
FOR OPTIMUM ADJUSTABLE BASE
OPERATION, USE A GROUNDED, ELECTRICAL
SURGE PROTECTION DEVICE (NOT
INCLUDED). FAILURE TO USE A SURGE
PROTECTION DEVICE COULD COMPROMISE
SAFETY OR CAUSE PRODUCT MALFUNCTION.
Designer Series™ 99301294
24
TROUBLESHOOTING
In the event the adjustable base fails to operate, investigate the symptoms and possible solutions provided in the chart below:
SYMPTOM
SOLUTION
• Verify power cord is plugged into a working, grounded
electrical outlet. A grounded, electrical surge protection device is recommended. Test outlet by plugging in another working appliance.
• Program the remote control (see Remote Control
Programming section of this manual for programming procedures).
• Unplug power cord, wait 30 seconds and plug in to
reset electronic components.
• Electrical circuit breaker may be tripped. Check
electrical service breaker box to verify.
• Defective surge protection device or electrical outlet.
Test outlet by plugging in another working appliance.
• Replace batteries in the remote control.
• Base mechanism may be obstructed. Elevate base and
check for obstruction. Remove obstruction.
• Head section may be too close to the wall.
• Headboard may be too close to the edge of the mattress.
Verify a 1.5” (38.1mm) to 2” (50.8mm) distance between headboard brackets and mattress. Adjust if required.
• Verify headboard brackets were removed during
installation. Remove headboard brackets if still attached to the underneath side of base.
• If base is located on hard surface fl ooring, place carpet
pieces or rubber caster cups under each leg or caster of the base. (See accessory section of this manual for rubber caster cup order information.)
• Elevate the head or foot section a short distance (with
the remote control) to realign the lift/lower mechanisms with the base support platform.
• Verify that the base is not positioned against a wall,
nightstand, or other object that may cause vibration or noise.
• If base is installed over a base frame, verify massage
motors are not causing base frame (or base frame components) to vibrate.
• Verify that headboard attachment hardware is tightened
fi rmly (if used).
Remote control illuminates and appears to be operable, but will not activate base.
No features of the base will activate.
Remote control will not illuminate.
Head or foot section will elevate, but will not return to the horizontal (fl at) position.
Excessive massage motor noise.
Loading...
+ 9 hidden pages