LGT202TX/RX
RADIO FREQUENCY REMOTE WITH LCD FOR GAS FIREPLACE
INSTRUCTION AND INFORMATION GUIDE
1. Introduction of Functions
- This RF Remote Control System is for Gas fireplace operations. It consists of a transmitter and a receiver. The system has
two modes; Manual and Auto.
- In Manual mode, the system turns the Flame ON /OFF and Sound (Firecrackler device).
- In Auto mode, the system regulates room temperature to a desired degree by automatically turning the flame ON and OFF.
- The system has an auto power off countdown timer for a max of 12 hours.
- An LCD display shows a back light for Flame and Sound status, Room temperature, desired Set temperature, Clock, Auto
power OFF countdown timer and Low Battery indicator.
- There is a Childproof lock-out for all the transmitter keys.
- The battery cover has a Childproof design.
- The system operates on a variable remote control address code. User can program the address code on the transmitter. The
code range is 1-250.
Transmitter:
- operates in both simple on/off or temperature control mode
- displays temperature and all functions with backlighting
- monitors room temperature each minute
- can control temperature from 49 º F to 99 º F (9 ºC to 37 ºC)
- has count down to OFF timer settable from 0 to 12 hours.
- has Childproof key locking and battery cover
- can be programmed to operate on one of 250 addresses
Receiver :
- can trun ON/OFF Millivolt valve or 24 volt valve
- can turn ON/OFF Firecrackler Sound System (external CF6)
- operates on 4-AA batteries
- address code learn function (1 to 250)
- has over-heat shut down protection
Receiver over-heat protection temperature: 65±5℃
Specifications
2.
RF carrier 433.92MHz
Transmitter power 2 AA alkaline batteries for approximately one year of service.
Receiver power 4 AA alkaline batteries for approximately one year of service.
Remote range Not less than 8 meters (20 feet).
Receiver output control ON/OFF Millivolt volt or 24 volt valves
ON/OFF Firecrackler sound device (External CF6)
Temperature range for transmitter operation: 0-40℃
Temperature range for receiver operation: 0-70℃
3. Transmitter Operations
3.1 LCD and KEY:
ONE: POWER OFF
: POWER ON an d FIRE OFF
: POWER ON and FIRE ON
RF Transmission
AUTO
MANU
AUTO Status
MANU Status
Fire Crackle Sound
Room Temperature
Thermostat set temperature
Child safety lock-out
ON Remote Control
OFF Remote Control
AUTO/MANU mode select
ON
OFF
MODE
Clock
Shut Off Timer
Low battery alarm
HI
Set point increase
LO
Set point decrease
SOUND
Fire Crackle Sound ON/OFF
TIMER
Set Shut Off Timer
or ℃ Selection
/℃
3.2 Battery installation
Remove the screw from the battery cover on the rear side of the transmitter, open the cover, and
insert 2 AA alkaline batteries Into battery holder.
When the batteries are in position, LCD displays current room temperature and clock
or ℃ Selection
3.3
Press
3.4 Clock display adjustment
Press CLOCK hole with a pen tip, and AM (or PM) will flash. Adjust the time by pressing HI or LO keys. AM (or PM)
will stop flashing within 3 seconds after the completion of the adjustment.
/℃ hole with a pen tip to select ℃ or degrees.
CLOCK
Clock adjustment