LegenTek 201TX Users Manual

LGT201TX/RX

RADIO FREQUENCY REMOTE WITH SIMPLE STRUCTURE FOR GAS FIREPLACE

USER MANUAL

1. Introduction of Functions

- This RF Remote Control System is for Gas fireplace operations. It consists of a transmitter and a receiver.

- The system turns the Flame ON /OFF.

- The system turns the Fire crackle Sound ON/OFF.

Transmitter:

- There is a Childproof lock-out for all the transmitter keys.

- The battery cover has a Childproof design.

- User can program the address code on the transmitter. The code range is 1-250.

Receiver :

- can trun ON/OFF Millivolt valve or 24 volt valve

- can turn ON/OFF Fire crackle Sound System (external CF6)

- address code learn function (1 to 250)

- has over-heat shut down protection

- operates on 4-AA batteries

Specifications

2.

RF carrier 433.92MHz

Transmitter power 2 AA alkaline batteries for approximately one year of service.
Receiver power 4 AA alkaline batteries for approximately one year of service.

Temperature range for transmitter operation: 0-40℃

Temperature range for receiver operation: 0-70℃

Receiver over-heat protection temperature: 65±5℃

Remote range Not less than 8 meters (20 feet).

Receiver output control ON/OFF Millivolt volt or 24 volt valves
ON/OFF Firecrackler sound device (External CF6)

3. Transmitter Operations

RF Transmission Indicate

ON

SOUND

Fire Crackle Sound ON

ON Remote Control

ON

Fire Crackle Sound OFF

OFF Remote Control

OFF

OFF

3.1 Battery installation

Remove the screw from the battery cover on the rear side of the transmitter, open the cover, and
insert 2 AA alkaline batteries Into battery holder.

3.2 Flame ON/OFF

Press ON/OFF key to control the flame ON/OFF, and the LED will light while transmits

3.3 SOUND
When flame is in ON position, SOUND ON/OFF key turns ON/OFF the Fire crackle device.

3.4 CHILD LOCK

To lock press both OFF and SOUND OFF keys, and LED flickers in 3 seconds indicating the remote control is locked.
To unlock, press both OFF and SOUND OFF keys and LED regularly lights in 3 seconds indicatin g the remote is unlocked.

3.5 CHANGING ADDRESS

To avoid inferences of two remote control systems of same model in one household, one of them needs to change its
address code. Press both ON and SOUND ON keys, and LED will flicker in 5 seconds, and the address code increases one
at each time LED flickers. The code range is 1-250.

4 Receiver Installation / Functions

4.1 Connect the Valve and Fire crackle Sound Device.

Make sure that the slide switch of the receiver is in OFF position. Connect the flame control wires (red and white) of the

receiver to the valve and sound control wires (blue and black) to Fire crackle Sound device.

4.2 Install Batteries

Press the small square button below the battery holder of the receiver, open the battery holder, insert 4- AA alkaline

batteries, and install the battery holder back into receiver.