Legacy Classic Furniture 3600-622 TRESTLE TABLE Assembly Instructions Manual
ASSEMBLY INSTRUCTIONS:
3600-622 TRESTLE TABLE
Parts & Hardware List:
Thank you for purchasing this quality product. Before beginning, please check the packing material
carefully for small parts which may have come loose inside the carton during shipping. Please do not
discard any packing material until all parts have been located. If any parts are missing, please contact
your dealer for prompt replacement.
8 PCS
3
5/16"*1-1/2"
2
HARDWARE LIST
SHORT BOLT
1
Q'TY
10 PCS
MEDIUM BOLT
LONG BOLT
5/16"*1-3/4"
5/16"*3-3/4"
5
WOOD DOWEL
5/16"
5/16"*23*2mm
FLAT WASHER
8
2 PCS
10*40MM
SPRING WASHER
4
20 PCS
20 PCS
HARDWARE LIST
Q'TY
PARTS LIST
Q'TY
TABLE TOP
B
A
1 PC 2 PCS
E
TABLE LEG
F
2 PCS
PARTS LIST
Q'TY
C
TABLE LEAF
1 PC
G
SHORT STRETCHER
LONG STRETCHER
1 PC
2 PCS
SHORT WRENCH
6
1 PC
70*30*4mm
LONG WRENCH
7
1 PC
70*30*5mm
Step 2
Step 3
Step 4
Step 5
Step 6
A
B
Adjustabl e
Leveler
G
E
4
5
3
7
8
E
F
F
6
A
7
7
2
4
5
4
5
7
2
E
E
C
1
4
5
7
D
BASE MOUNTING
PLATE
1 PC
TOP MOUNTING
PLATE
1 PC
C
D
7
6
1
4
5
7
A
C
D
ASSEMBLY INSTRUCTIONS:
3600-622 TRESTLE TABLE
Assembly Procedures:
Step 1: Lay out all parts and hardware. Make sure the quantity of each is correct and the feet are free of
stain, staples, screws and nails.
Step 2: Remove the base mounting plate (C) and top mounting plate (D) from the table top (A) which is
fixed on the under side of the table top by detaching bolt, spring washer and flat washer with
wrench.
Note
: Do not throw away the hardware when you remove the mounting plates (C&D) from the under
side of table top.
Step 3: Assemble the short & long stretchers (F&G) to the table legs (E) as shown.
Step 4: Assemble the table legs (E) and short stetchers (F) to the base mounting plate (C) as shown.
Step 5: Place the table top (A) face down on a clean soft flat surface such as a blanket and ensure the
surface is clear of any objects that could scratch or damage the top.
Assemble the legs with base mounting plate (C) to the top mounting plate (D) and table top (A)
as shown.
Step 6: Turn the table to its upright position. Unlock the lock mechanism under the table top before
pulling it apart and then carefully insert or remove the table leaf.
Use adjustable levelers as necessary.
Note
: If handled improperly, the act of installing and removing table leaves may damage the table.
Please use caution and delicate handling when installing and removing table leaves to prevent
damaging the table top surface and edges. It is best two persons are involved when installing or
removing table leaves.
Caution: Over-tighting screws or bolts may result in damage. It is suggested that at least two people
work together for this assembly process to avoid injury. Following assembly, the furniture should be
cleaned with a quality, non-silicone furniture polish on a clean, soft cloth.
www.legacyclassic.com
Loading...