Legacy Classic Trundle Storage Drawer User Manual
Assembly Instruction 9500 Trundle/Storage Drawer
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts that may have come loose
inside the carton during shipment.
Caution: (1) These parts are cumbersom e and heavy. This product can best be assembled with the assistance of one or more persons
in order to prevent personal injury and t o insure parts are not damaged during the assembly process. If dirty, clean finished parts with
mild dishwashing liquid and water solution applied on damp clot h. Cl ot h shou ld not be e xcessi vel y wet. P olish fi nis h with sof t cloth and
an industry recognized furniture polish.
surfaces and also check for staples or nails left after removing the packaging material. The manufacturer will not be held responsible if
preventative steps are not taken prior to installation.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for stain residue and rough
PARTS LIST:
Description Q’TY Description Q’TY
Front Panel (A) 1 PC Bottom Panel (E) 1 PC
Left Side Panel (B) 1 PC Divide Panel (F) 2pcs
Right Side Panel (C) 1 PC Hardware list (see below)
Back Panel (D) 1PC
Assembly Procedures:
1. Lay out all the parts and hardware. Make sure the quantity of each it correct.
2. See Figure 1& 2, connect four panels together. Front Panel (A), Left Side Panel (B), Right Side Panel (C), Back Pane l ( D ) by
using the long bolts (1). Please be sure not to tighten the bolts too much until the Bottom panel (E) is laid down. And then position
the bottom panel into the clots around the four sides.
3. See Figure 3, turn the whole unit upside down. Using Lock washer (4), flat washer (3), Bolts (2) through the cleats of four sides,
and tighten with Spanner (5).
4. Install the Swivel Casters (6) and Flat W ashers (8) into block of Bottom panel (E) and use the Wrench (7) to tighten it.
5. See Figure 4: Turn the unit right side up and insert two Divide panel (F) along the scores for use as a storage drawer, or
6. See Figure 5: Insert trundle size mattress (Maximum size 38”*73”*8”H) for use as trundle bed.
7. See Figure 6: push the whole unit under the bed.
1
1
B
A
B
D
D
1
A
C
1
C
Figure 1
Figure 2
Page 1 of 2
Assembly Instruction 9500 Trundle/Storage Drawer
2
6
1
2
3
4
BOLT
BOLT
FLAT WASHER
LOCK WASHER
8
7
E
Figure 3
s
r
e
d
i
v
Di
l
a
n
o
i
t
Op
F
Figure 4
Mattress
Figure 5
s
r
e
d
i
v
i
D
l
a
n
o
i
t
p
O
F
5
6
7
8
SPANNER
CASTER
WRENCH
FLAT WASHER
mm
5/16"
6
mm
6
Figure 6
Note: Bed rail s must be rail ed to upper locking position.
Special Instruction: To avoid soiling carpets always wipe any excess stain residue off the bottom of the legs with a cloth rag before
assembly the placing the furniture on carpeting. During normal everyday use bolts and nuts may loosen up. They should be periodically
inspected and re-tightened to prevent damage to the furniture or cause injury. Always check to be sure all hardware on this list is
attached and kept tightened.
Page 2 of 2
Loading...