This DVD Player Is A Class I Laser Product. However This DVD Player Uses
A Visible/invisible Laser Beam Which
Could Cause . Hazardous Radiation
Exposure If Directed.
Be Sure To Operate The Dvd Player
Correctly As Instructed.
Use Of Controls Or Adjustments Or
Performance Of Procedures Other Than
Those Specified Herein May Result In
Hazardous Radiation Exposure. do Not
Open Covers And Do Not Repair Yourself. Refer Servicing To Qualified
Personnel.
REGION MANAGEMENT
INFORMATION:
This DVD Player is designed and manufactured to respond to the Region
Management Information that is recorded on a DVD disc. If the Region number
described on the DVD disc does not
correspond to the Region number of this
DVD Player, this DVD Player cannot
play this disc.
This product incorporates copyright
protection technology that is protected
by method claims of certain U.S. Patents
and other intellectual property rights
owned by Macrovision Corporation and
other rights owners.
Use of this copyright protection
technology must be authorized by Macro
vision Corporation, and is intended for
home and other limited viewing uses
only unless otherwise authorized by
Macrovision Corporation.
Reverse engineering or disassembly is
prohibited.
WARNING:
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR
MOISTURE.
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, AND ANNOYING
INTERFERENCE, USE ONLY THE
RECOMMENDED ACCESSORIES.
THIS DEVICE IS INTENDED FOR
CONTINUOUS OPERATION.
-2-
DISC NOTES
Disc formats supported by this
player
DVD
VCD
CD
Audio and Video
Discsize12cm
Audio and Video
Discsize12cm
Audio
Discsize12cm
(although not enough to make it unusable) depending on your handling it and
conditions in the usage environment.
Note these scratches are not an indication of any problem with the player.
Label side
up
MP3
MPM
CD-RW
P
3
Audio
Discsize12cm
Discs which cannot be played
with this player
DVD-ROM
DVD-RAM
CDV
CD-G
Handling and Cleaning
Dirt, dust, scratches and warping disc
will cause misoperation.
Do not place stickers or make
scratches on discs.
Do not warp discs.
A disc should always be kept in its
case when not in use to prevent from
damaging.
Do not place discs in the following
places:
1.Direct sunlight
2.Dirty, dusty and damp areas
3.Near car heaters
4.On the seats or dashboard
Disc Cleaning
Use a dry soft cloth to wipe the surface.
If the disc is quite dirty, use a soft cloth
slightly moistured with isopropyl
(rubbing) alcohol. Never use solvents
such as benzine, thinner or conventional
record cleaners as they may mar the
surface of the disc.
Note:
A disc may become somewhat scratched
Do nottouch
the
underside
of thedisc
Do not
bend
Wipe the disc from
center
toward theoutside
edge
Preparing New Discs with
Rough
Spots
A new disc may have rough edges on
its inside and outside edges.If a disc
with rough edges is used, the proper
setting will not be performed and the
player will not play the disc.Therefore,
remove the rough edges in advance
by using a ball point pen or pencil as
shown on the right.To remove the
rough edges, press the side o f the pen
or pencil against the inside and outside
edges of the disc.
Rough spots
on
outside edge
Ball pointpen
or pencil
Rough spots
on inside
edge
-3-
INSTALLATION
NOTES:
Choose the mounting location where the
unit will not interfere with the normal
driving function of the driver.
Before finally installing the unit, connect
the wiring temporarily and make sure
is
all connected up properly and the unit
and the system work properly.
Use only the parts included with the unit
to ensure proper installation. The use
unauthorized parts can cause
malfunctions.
Consult with your nearest dealer if installation requires the drilling of holes or
other
modifications of the vehicle.
Install the unit where it does not get in
the driver s way and cannot injure the
'
passenger if there is a sudden stop,
like an emergency stop.
it
of
If installation angle exceeds 30 from
horizontal, the unit might not give its
optimum performance.
30
Avoid installing the unit where it would
be subject to high temperature, such
as from direct sunlight, or from hot air,
from the heater, or where it would be
subject to dust, dirt or excessive
vibration.
DIN FRONT/REAR-MOUNT
This unit can be properly installed either
from "Front"(conventional DIN Frontmount) or "Rear"(DIN Rear-mount
installation, utilizing threaded screw
holes at the sides of the unit chassis).
For details, refer to the following
illustrated installation methods.
SPRING WASHER
PLAIN WASHER
TAPPING SCREW
HEX NUT
DASH BOARD
METALMOUNTING
STRAP
CONSOLE
SLIDE BRACKET
HOUSING
-4-
HEX BOLT
INSTALLATION
KEY PLATE
PLASTIC COVER
KEY PLATE
If you want to take CHASSIS out of the SLIDE BRACKET HOUSING , first remove
the PLASTIC COVER of the both sides away, then insert the two KEY PLATE into
left and right side of chassis as above illustration.
DETACHING THE FRONT PANEL
1. Press thebutton to flip down the
front panel .
OPEN
OPEN button
2. Slide the guide knob to remove the right
side first, slide it to the left, and pull it off
towards you .
GUIDE Knob
-5-
INSTALLATION
3. put it in the protective case for safe
keeping.
PROTECTIVE CASE
FRONT PANEL
REPLACING THE FRONT PANEL
1. First, insert the left side of the front
panel into the main unit.
2. Push the right side of the front panel
until it locks firmly into the main unit, at
one time, insert the right side of the
front panel into the main unit .
3. Push it back to the position for playing
Bulge
Hollow
Bulge
Hollow
-6-
ELECTRIC CONNECTION
WIRING CONNECTION
FRONT RCA RED R
VIDEO OUT 1 YELLOW
FRONT RCA WHITE L
GREY SUBWOOFER
VIDEO OUT 2 YELLOW
COAXIAL OUT BROWN
IGNITION SWITCH(B+)
MEMORY BACK-UP(B+)
GROUND(B-)
AUTO ANTENNA
RCA cable
RCA cable/output
front
RED
YELLOW
CHOKE
BOX
BLACK
FUSE
BLUE
RCA cable/output
rear (optional)
BROWN
ORANGE
YELLOW
RCH RED
LCH WHITE
Radio antenna jack
(B+)12V
REAR CAMERASWITCH
(B-)PARKING BRAKE
REAR CAMERAINPUT
FRONT
Lch SPK.
REAR
Lch SPK.
WHITE
WHITE/BLACK
GREEN
GREEN/BLACK
GREY
GREY/BLACK
VIOLET
VIOLET/BLACK
FRONT
Rch SPK.
REAR
Rch SPK.
Note:
the earth connection cable (parking brake B-) must be connected in order for DVD
pictures to be played back to the monitor. If the cable has not been correctly
connected, the message “PARKING BRAKE” appears on the monitor.
-7-
Loading...
+ 18 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.