Legacy Car Audio LCD75DFX User Manual
SPECIFICATION
GENERAL
Supply Voltage DC 13.8V. Negative Ground
Current Consumption Max.7A
Power Output 40W X 4.
Unit Dimensions 178[W] X 50[H] X 165[D] mm.
FM SECTION
Frequency range 87.5MHz -107.9MHz (USA)
87.5MHz -108.0MHz (EUR)
Effective sensitivity 3uV.
I.F Frequency 10.7MHz.
AM SECTION
Frequency range 530KHz - 1710KHz (USA)
522KHz - 1620KHz (EUR)
I.F Frequency 450KHz
RCA LINE OUT (OPTION)
Output CD Max. 1200mv
CD PLAYER
System Compact Disc Audio System.
Suitable CDs CD/CD-R/CD-RW Disc
Signal format Sampling frequency 44.1KHz.
No. of quantization bits 1bit.
Frequency characteristics 20-100Hz < 5dB
10-20KHz < 5dB.
S/N Ratio to CD 50dB [1KHz]
Number of channels 2 STEREO channels.
\
\
LEGACY
LCD75DFX
INSTRUCTION MANUAL
11
ANTI-THEFT FLIP DOWN DETACHABLE SYSTEM
AUTO-LOADING COMPACT DISC PLAYER
AM/FM-STEREO DIGITAL PLL TUNING RADIO
WITH INFRARED REMOTE CONTROLLER
DEAR CUSTOMER:
Thank you for your purchase and confidence in all kinds of audio-visual products of ours.
Selecting fine audio equipment such as the unit you have just purchased is only the start
of your musical enjoyment. Now it is time to consider how you can maximize the fun and
excitement your equipment offers.
We hope you get the most out of your equipment by playing it at a safe level.
One that lets the sound comes through loud and clear without annoying blare or distortion,
and, more important, without affecting your sensitive hearing.
Sound can be misled. Over time your hearing " comfort level " adapts to higher volumes
of sound. So what sounds " normal " can actually be loud and harmful to your hearing.
Guard against this by setting your equipment at a safe level BEFORE your hearing adapts.
To establish a safe level:
Start your volume control at the lowest setting , then slowly increase the sound until you can
hear it comfortably and clearly, and without distortion we want you listening for a lifetime.
Once you have established a comfortable sound level:
Set the dial and leave it there.
Taking a minute to do this now will help to prevent hearing damage or loss in the
future. After all, we want you listening for a lifetime.
ABOUT THIS MANUAL
This product features a number of sophisticated functions ensuring superior reception and
operation. All are designed for the easiest possible use, but many are not self-explanatory.
This operation manual is intended to help you benefit fully from their potential and to
maximize your listening enjoyment.
TROUBLE SHOOTING
Before using the check list please make all the connections first.
If you still have questions after going through the checklist, please consult
your local customer service representative.
Common Symptoms
There is no power.
The CDs cannot
be loaded.
The CDs are loaded
only halfway into
the CD tray.
The device does
not work correctly
(EJECT, LOAD,
PLAY)
There is no sound.
The operation keys
do not work
Cause
The car ignition is switched off.
The fuse has blown.
Presence of CD disc inside the player
The transport screws have not been
removed.
Inserting the disc in upside down
The surface of CD is extremely dirty
or it is damaged.
Temperature inside the car is too
high.
The volume control is set too low.
The device has not been correctly
connected.
1.The built-in microcomputer is not
operating properly due to noise
2.Front panel is not properly fix into
its place
If the power supply is properly connected to
the car accessory, switch the ignition key to
ON or " ACC " " " .
Replace another fuse according to the wiring
diagram.
Remove the disc in the player then put a new
upward
Remove the transport screws before using.
Insert the compact disc with the label facing
upward
Clean the CD or try another CD, if this works
correctly, the first CD is properly damaged.
Cool off until the ambient temperature returns
to normal
Turn up the volume properly.
Check the power and earth connection
according to the wiring diagram.
1. Switch the device off and on again. Or press
the RESET button to resume the program.
2. Reinstall the front panel
Solution
We recommend that you familiarize yourself with the functions and their operation by
reading through the manual before you begin using this product. In this operation manual,
the Basic Operation for each sound source is outlined at the beginning of its explanation,
covering simple operation for that source, such as merely playing music.
The sound of the
CD player skips
No radio reception.
In automatic search
mode the radio does
not stop at a transmitting station.
The installation angle is more than
30 degrees
The surface of the road is uneven.
The surface of CD is extremely dirty
or it is damaged.
The antenna cable is not connected. Insert the antenna cable firmly into the
weak.
Adjust the installation angle to less than 30
degrees
Wait until the road becomes smoother before
playing the CD.
Clean the CD or try another CD, if this works
correctly, the first CD is properly damaged.
antenna socket of the device.
Tune in to a radio station manually.The transmission signals are too
101
Loading...