Legacy Audio Streamline Owners Manual

Registration

3. Owners Record

Setup

4. Unit Connections

6. Front Panel Controls

8. Remote Control

9. Unit Care

Technology

10. Designer’s Note

12. Specifications

2

The model and serial numbers are located on the rear of the unit. Record
these numbers in the spaces provided below. Refer to them when calling
upon your dealer regarding this product.

Model No. _______________________________
Serial No. _______________________________
Date of purchase: _________________________

Thank you for selecting a Legacy Audio System. Please take a few
moments to read this brief manual to insure maximum benefit from your
electronic system.

3

Rear Panel Connections

Be certain the Streamline and all associated equipment is turned off
before making any connections.

A. Balanced Inputs: Signal input is made through two XLR

(balanced) type connectors and six gold plated RCA (unbalanced)
type connectors. The XLR pin configuration is as follows: ground is

pin 1, positive is pin 2, and negative is pin 3.
B. Selector Inputs: Unbalanced stereo RCA jacks.
C. Tape Monitor: Signal input and output connections for a recording

device.

4

D. Processor: Signal input and output connections for a audio

processor (surround sound processor, equalizer, etc.)
E. Main Outputs
F. Balanced Outputs: Signal output to your amplifier is made through

two gold plated RCA (unbalanced) type connectors and two XLR

(balanced) type connectors. The XLR pin configuration is as

follows: ground is pin 1, positive is pin 2, and negative is pin 3.

G. AC Line Input: Insert the power cord into the AC receptacle and

then connect it to an appropriate power source. The fuse can be

removed by pulling the fuse drawer out and clipping in a new one.

Once all connections are made the power switch may be set to the

on position. The Streamline may be left on as it draws a negligible

amount of power. NOTE: The AC line voltage is preset at the

factory but may be changed upon your request.

5