Legacy Audio Mist Owners Manual

Registration

3. Owners Record

4. The Cabinetry / Our Commitment

Setup

5. Unpacking Your Speakers

6. Speaker Placement / Installation

8. Hook up Cables

10. Amplification

13. Speaker Connections

Technology

14. Designer’s Note

16. Specifications

2

The model and serial numbers are located on the rear of the unit. Record
these numbers in the spaces provided below. Refer to them when calling
upon your dealer regarding this product.

Model No. _______________________________
Serial No. _______________________________
Date of purchase: _________________________

Thank you for selecting a Legacy Loudspeaker System. These hand­crafted instruments will provide you with many years of listening
enjoyment. Please take a few moments to read this brief manual to insure
maximum benefit from your speaker system.

3

Handcrafted

Beneath the surface of MiST’s elegant exterior lies rigid MDF construction.
Interlocking joinery maximizes the strength of the cabinet parts. Polyester
fiberfill is selected for internal damping. A sharp rap on the enclosure will
leave you with little more than bruised knuckles.

Each cabinet is impeccably finished on all exposed surfaces with select
veneers. The exquisite finish is hand-rubbed several times to assure a
patina at home with the most elegant decor.

Our Commitment

A great deal of forethought, love and satisfaction is instilled in each piece
of Legacy workmanship. We take pride in getting to know many of our
customers on a first name basis.

Your purchase of this product is backed by the renowned “Legacy
Satisfaction Guarantee”.

4

Your new speaker system has been very carefully packaged to insure that
it travels to you safely. Each speaker is protected by a heavy outer carton
with V-board corner protectors. Molded foam end caps are used to protect
the elegant cabinetry, and a plastic liner is provided as waterproofing.
Please save this packing for future transportation. If cartons become
damaged or misplaced, new ones can be purchased from Legacy Audio.

5

A pair of MiST should be wall mounted approximately 6’ high and to the
sides of the listener. An optional third MiST may be used as a center rear
channel by mounting the unit behind the listener. Because MiST is actually
two independent, opposite facing, side-firing arrays in one cabinet, it
behaves as a bipolar system. When used behind the listener it may be
powered by both the left and right rear channel inputs.
Though the MiST requires only one channel of amplification per unit to
drive it when configured in the standard mode, separate input terminals for
each array allow for future steering versatility.

Instructions for attaching bracket to wall

1. Selecting a mounting site.

Note: Try to find a site with a solid wood backing.

2. Using one of the brackets as a pattern, mark four holes on the wall,
aligning the vertical holes with a stud location.

3. Drill four 1/8” (.32 cm) diameter holes as marked.

4. Fasten one bracket to the wall with four wood screws provided. (See
Figure 1)

6