Lega P-600, P-650, P-850, K-1000, K-1200 User Manual

P-600, P-650, P-850, K-1000

K-1200, T-1500, T-2000

Uninterruptible Power Supply

USER’S MANUAL

Please keep this manual with UPS!

Please read and understand this instructions manual!

This manual provides safety, installation and operation instructions which will
guide you to the best performance of your equipment.

Please keep this manual!

It includes important instructions fort he safe usage of the equipment and to
obtain manufacturer’s Support in case of need.

Please keep or recycle the packaging materials!

Packaging materials used in our products are designed to provide protection
from transportation.
These materials are necessary in case that the equipment needs to be shipped
back for service. Damage that may ocur during the shipment is not covered by
the product’s warranty.

INTRODUCTION
1-1 System Description

This product is line interactive UPS with LED indicators, newest technology
and powerful functions.
The Line Interactive UPS is designed with 2-Steps Boost and 1-Step Buck AVR
to stabilize input voltage. Input voltage range is -%30, +%25, but output
regulation is ±10%.
The Line Interactive UPS provides you with the ability of perfect protection for
your critical devices.

1-2 Features

 Line Interactive design
 Mikroprocessor control guarantees high reliability
 Frequency 50Hz/60Hz auto-sensing
 Equipped with 2-Steps Boost and 1-Step Buck AVR to stabilize input

voltage

 Built-in DC start function anable UPS to be started up without AC power

supply

 UPS Green Mode (Energy Saving Function)
 Off-mode Charging
 Modem/Phone line surge protection
 Over/Low Voltage, Short-Circuit, and Lightning/Surge (Optional)

protection

 Built-in CCCV ( Constant Current, Constant Voltage) battery charger

CAUTION

 The UPS contains voltage that is potentially hazardous. Qualified

or certified technician should proceed all repairs and
maintenance.

 The UPS has its own internal energy source (battery). The output

receptacles may be active even when the UPS is not connected to
an AC supply.

 The UPS is suitable for computers and electronic equipment with

substantial rectifier or capacitive loads, not suitable for
electronic equipment with significant inductive loads, such as
motors & fluorescent lamps.

 Be sure to operate within the power rating of the UPS. Below ½

or 1/3 of the rated power is recommended for longer backup
time & longer battery life.

 Do not place the UPS near excessive humidity, under sunshine or

close to heat emitting sources.

 If the UPS is out of order, detach the power cord and consult your

dealer right away. Do not remove cover; there is no serviceable
part inside.

 The unit should be supplied by a grounded Source. Do not

operate the unit without a ground source.

 The socket should be installed near the equipment and be easily

accessible.

 Do not plug the UPS’s power cord into itself. That will result in a

safety hazard.

 A qualified technician or electrician in accordance with local

electrical code should perform installation.

INSTALLATION

The UPS must be installed in a protected environment away from heat-emitting
appliances such as a radiator or heater. Do not install this product where
excessive moisture is present.

Caution: Never connect a laser printer or plotter to the UPS. A laser printer or
plotter periodically draws significantly more power than its idle status and
may overload the UPS.