Lee Technology Korea LT2005W Users Manual
WATCH TYPE PAGER
(LT2005W)
OPERATION MANUAL
FCC ID : QBT-LT2005W
Trade Name : WATCH PAGER
Model No. : LT2005W
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS :
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
NOTE:THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT.SUCH MODIFICATIONS COULD VOID THE USERʼS AUTHORITY TO
OPERATE THE EQUIPMENT.
www.leetek.org
leetek2001@yahoo.co.kr
Lee Technology Korea.Co.,Ltd(LEETEK)
rd
#499-2 Sang3dong, Wonmi-gu,
3
Puchon-city, kyunggi-do, Korea
T:82-32-324-9838/9
F:82-32-324-9840
WATCH-TYPE PAGER
1. PICTURE
2. SPEC
z 12 Segment Display
z 1.5V AAA Battery Included
① Top Button
② Side Button
z 2 Button Switch (Top Button, Side Button)
z Vibe Alert
z Maximum 12 Table Number Can Be Stored.
3. POWER ON/OFF
1) ON – Press the side Button for more than 5 seconds, and then it will be
turned on.
2) OFF – Press the side button for more than 5 seconds, and then it will be
turned off.
4. Time Setup
1) If you want to enter the Time Setting Mode, insert the battery. And then, you
can automatically enter to the Time Setting Mode.
2) To change the number of the hour or the minute, press the side button.
3) Press the top button, to change the location of the edit bar from the hour to
the minute.
4) It will be automatically exited to the initial screen after 3 seconds without any
input.
5. Enter Table Setting Mode
z To enter the Table Setting Mode, press the Top Button about 2 seconds.
And then it will enter the Table Setting Mode.
6. Alert Mode
z When the message is received, the vibration works for 15 seconds. If you
push the button, the vibration will be stopped.
7. Message Reading
1) If you press the Side Button, “Call” is displayed.
2) The received message will be displayed if you push the Side Button once more.
8. Erase Message
z To delete the message, make the display screen indicating the table
number.
z Then press the Side Button 3 seconds. The corresponding message will be
erased.
9. Battery Information and Replacement
1) Watch-Typed Pager is designed to use a single AAA alkaline battery.
2) To replace the battery, do the following.
- Slide the locking switch to the unlock position.
- Take out the battery over.
- Remove the old battery and insert a new AAA battery in the direction shown
on the battery compartment.
- Slide the battery cover back on the pager and slide the battery lock switch to
the locked position.
GuestCall Troubleshooting
Charge light will not come on
a. Make sure there is power to the outlet
b. Try changing the position of the coasters on the stack. Make sure they are seated
properly with the numbers facing front.
c. Using a damp rag, clean metal contacts on coaster that will not light
Loading...