LeeSan Cinderella Comfort Installation Manual

INSTALLASJON y INSTALLATION y ASENNUSOHJE

CINDERELLA COMFORT

Opening the package

Check that the package has not been damaged during transport. Contact the shipper or seller if the packaging has any holes or
signs of damage from impact. Check the contents for visible damage.
The guarantee certificate is enclosed with the toilet. Secure your rights under the guarantee by registering. In cases of theft,
registered Cinderella appliances will be listed in the manufacturer’s database. When registering, you will also be able to utilise the
manufacturer’s support systems.

Transport safety strap

The ash container is equipped with a
safety strap which must be removed
before use as follows:

Registration

You can register your toilet on the Internet:

www.register.cinderellaeco.com

1. Remove the front hatch

2. Cut away the plastic straps attaching
the ash container to the steel frame.

3. Remove plastic straps.

Proper installation - long service life

Installing your Cinderella Comfort correctly has a num­ber of advantages:

• Odour free toilet compartment and more efficient
incineration.

• Quieter operation.

• Avoids cold air/cold downward air draft.

In order to ensure the best possible incineration and
safe operation over a longer period of time, it is
important to install air inlet and outlet pipes correctly.
Incorrect installation may cause poor incineration,
odours and other problems. Ensure that installation
is performed in compliance with electrical and building
regulations. If you are unsure of this, contact a
professional tradesman.

Transport safety strap

Outlet air

Inlet air

Inlet / outlet air:

The internal air balance and temperature conditions
of the room will not be disturbed by the Cinderella since
the required inlet air is drawn through a dedicated inlet
pipe and all outlet air/vapours are vented through a
separate pipe.

The package contains

1 ea. Cinderella Comfort
1 box Original paper bags (500 bags)
1 ea. Outlet air pipe, 110 mm dia. by 430 mm length
1 ea. Inlet air pipe, 110 mm dia. by 430 mm length
1 ea. T-piece, 110 mm dia. (90°)
1 ea. Ventilator cowl
1 ea. Weather cap
1 ea. User guide

1 ea. Installation guide

20

If you follow the instructions carefully,

your incineration toilet will provide good service

for many years.

Examples of installations

Cinderella Comfort may be installed in several different ways. However the most important thing is to ensure good inlet and
outlet air flow. The illustrations below show 2 alternative installations :

Alternative A

This is the recommended method for installation.
Inlet air flows through an external pipe connected
to the rear wall of the toilet. The outlet air pipe extends
through any overhanging parts of the roof, internally or
externally.

Alternative B

This is an alternative configuration. Inlet air is provided
from inside the room, which must have a separate air
vent of at least 160 mm diameter. The outlet pipe is
routed either inside the toilet or through and up an out­side wall. This alternative is typically used where in lower
temperature environments. Note: an extractor fan can
not be used in the toilet with this alternative.

Inlet air Inlet air

See more installation possibilities on www.cinderellaeco.com

1. MATERIALS

Depending on the type of installation as shown above, you
should select the required materials from the list below.

• Outlet air pipe bend

• Inlet air pipe bend

• Wall fittings for outlet air pipe

• Feed-through for extending the pipe through external

roof. The type of feed-through will depend on the

material used for roof covering.

• Inlet air vent, min. 160 mm diameter / 201 cm2

section

2. TOOLS

• Drill

• Hole saw 111 mm, for cutting holes for outlet air

pipe and inlet air pipe

• Hole saw 168 mm, for cutting hole for inlet air vent

• Long drill bit for drilling pilot hole through wall

• Saw

• Folding rule

• Marker pen

• Rasp or file

21