LEEGOTECH H 152BT User Manual

Instructions

1.Feature:

Bluetooth specification: Bluetooth 4.1 + EDR specification.
Battery capacity: 120mAH.
Bluetooth protocol: HFP v1.6, HSP v1.2, A2DP v1.3, AVRCP v1.5, SPP v1.2
Audio performance: Support SBC, MP3, AAC, stereo.
Bluetooth distance: 10 meters (accessibility).
Working time: 4 hours.
answer / hang up the phone, call waiting, volume adjustment, up and down the first
switch, the music play / pause, power and connected to the voice prompts,
maximum / minimum volume of voice prompts, telephone redial, Bluetooth phone
home.
can simultaneously connect two mobile phones.
Caller ID voice reporting
power display

2.The operating instructions:

a. Power: Long press the answer key to boot, until you hear a tone switched (voice

prompt boot) and the light blue lights flashing.

b. Bluetooth pairing: Press answer key to boot, until you hear a tone paired (voice

prompts to enter pairing mode) and the indicator light alternately flashes red and
blue light, to find the appropriate name Bluetooth devices on your phone, click on
the device name on the phone screen Bluetooth pairing After successful pairing,
paired hear the tone (voice prompts paired connected), blue indicator light

flashes.
c. off: long press the answer button off (the voice prompts shutdown).
d. Charging: When charging, the indicator red light, blue light after full.
e. Charging voltage: 5V
f. Charging way: MICRO 5PIN USB port.
g. volume up: Press the volume up button to adjust the volume,
h. volume down: Press volume down button to adjust the volume.
i. a song on switching: short press volume down key on a first switch.
j. next song switch: Short press volume up button to switch to the next header.
k. music playback: Short press the answer key.
l. Music Pause: short press the answer key.
m. answer / hang up: press the answer key.
n. phone Redial: Press twice to redial the last call answer key number.
o. mobile phone connection: first open at two mobile phones, Bluetooth device is

turned into pairing mode, two phones at the same time find the appropriate

Bluetooth device name, then click on the device name on-screen pairing two

phones (voice prompts pairing successfully connected, the second device is

connected successfully).

3.FCC STATEMENT

1). This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.

2). Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
(4) Consult the dealer or an experienced radio/TV technician for help.

RF warning statement:

The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.