Leedarson Lighting 7ASSAABCH Users Manual

7A-SS-AABC-H0

We build your success in IoT.

LEEDARSON Multi Sensor

Content:

Multi Sensor ....................................................................................................................................................... 2

1. Product Introduction ............................................................................................................................ 2

2. Product Appearance ............................................................................................................................ 2

3. Specification ......................................................................................................................................... 3

4. Features/Capabilities: .......................................................................................................................... 4

5. Installation Position and Notes ............................................................................................................ 4

6. Product Installation .............................................................................................................................. 5

7. Product Usage ...................................................................................................................................... 5

8. Attention .............................................................................................................................................. 7

Multi-Sensor

Quick Start Guide

1. Product Introduction

The Multi-sensor is designed for using with scenes in home automation systems, integrate motion, light ,
temperature and humidity sensors, powered by CR123A battery or USB cable. The Motion Sensor lets you
know when movement is detected in a certain area and can trigger different actions in response to that
movement (or lack of movement). It also lets you know the ambient temperature and humidity to trigger
different actions to make you more comfort. This sensor integrated Z-Wave communication module to
connect with Z-Wave gateway, and this device can be adapted to EU(868.42Mhz) or US(908.42MHz).

2. Product Appearance

Product appearance and function overview.

① Button:

 Short press reset button into learning mode, then the sensor can inclusion or exclusion from the Z-

Wave network.

 Hold the key for 5s to reset the sensor, after reset, Multi-Sensor will send “Device_Reset_Locally”

to the main controller and exclude from the Z-Wave network when the Button is released, this
procedure will reset the Sensor to factory default.

 Short press button for 3 times then the sensor sending wake up notification to gateway,

wake up for 10 seconds.

② LED Indicator: if sensor has not been added to controller, the LED will blink for 5 seconds. The LED will

keep on 3 seconds when joined to controller successfully.

2

3. Specification

Module Name

7A-SS-AABC-H0

Detection Technology

PIR （Passive Infrared）

Detection Angle

110°±10°

Detection Distance

5 meters

Temperature Accuracy

±1℃

Humidity Accuracy

±5%

Communication Protocol

Z-Wave

Radio Frequency

908.42MHz (US)

868.42MHz (EU)

921.42MHz (AU)

Wireless Range

More than 100m outdoors
About 30m indoors (depending
on building materials)

Power Source

USB (Built-in CR123A battery)

Battery Life

1 year

Mounting

Screws or 3M Tape

Mounting Height (recommended)

6.5 ft to 8.5 ft (2m to 2.8m)，recommend 2.5 meters

Mounting Location

Wall Surface

Operating Temperature

-10°C to + 45°C

Operating Humidity

Up to 85% non-condensing

Certifications

CE/FCC,Z-Wave

Dimensions (mm)

51(L)X51(W)X42(H)

OTA

Yes

3