LEEAN Vision Drive Installation Manual

LEEAN Global Business & Trading

B-302, Dongkuk Building, 76-284
Gocheok-Dong, Guro-Gu, Seoul, 152-826 Korea

CAR BLACK BOX

Installation & Use Quick Guide

LEEAN Global Business & Trading

B-302, Dongkuk Building, 76-284
Gocheok-Dong, Guro-Gu, Seoul, 152-826 Korea

WARNING

Until the initial boot is up or the upgrade patch is fully installed,
do not turn on or off the power source, for this may disengage
the power source and effect the booting process.

This product only works with the Vision Drive SD cards.

Only use the enclosed cable to connect your product.

Clean any impurities on the area of installation or any other area
where the camera will be positioned.

While the black box is in operation, do not remove the SD card.

Operate the product manually when the vehicle is parked in a safe place.

For disassembling, turn off the power completely before proceeding.

Do not disassemble, remodel or repair the product.

Product Installation

1. Connect the bracket and the unit

Place the bracket into the slot then slide to the left
to click on.

2. Insert SD card

Insert the SD card into the SD card slot on the side of the unit.

LEEAN Global Business & Trading

B-302, Dongkuk Building, 76-284
Gocheok-Dong, Guro-Gu, Seoul, 152-826 Korea

3. Connect the cable to the unit and attach to the windshield

Connect the power cable and then remove the sticker cover.
Place the unit on the area where you have cleaned for any
impurities. Place the unit close to the mid section of the vehicle.

4. Connect to cigar jack

Insert the adaptor into the cigar jack.

5. Turning it on and setting the camera angle

Insert the key in to the ignition and then slightly/fully turn the key
to give power to the cigar jack outlet. A voice notification will
alarm and the LED lights will blink to let you know that the
system is fully on.