LEDone Distribution Inc LOD-KFL20W-K, LOD-KFL30W-K, LOD-KFL50W-K Installation Instructions Manual

Phone: [phone] | Fax: [phone] | Web: www.ledonedistribution.com | E-mail: [e-mail]

`

FLOOD LIGHT INSTALLATION INSTRUCTIONS

LOD-KFL20W-XXK LED FLOOD LIGHT FIXTURE
LOD-KFL30W-XXK LED FLOOD LIGHT FIXTURE
LOD-KFL50W-XXK LED FLOOD LIGHT FIXTURE

IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.

JUNCTION BOX MOUNTING

Mount to a weatherproof junction box and cover plate (not supplied) as shown. To ensure weatherproof seal, apply
weatherproof silicone sealant back of junction box. This is especially important with an uneven wall surface.

1. Thread fixture into Cover Plate. Seal arm thread using Teflon tape or silicone sealant.

2. Connect wires correctly.

3. Attach cover to Junction Box.

4. Aim floodlight in the direction desired and tighten locknut and Arm Screw.

Flood

Screws

Junction

(not supplied)

Cover Plate

(not supplied)

Junction

(optional)

Cover

(optional)

Flood

Leveling Bubble

Knock Out Solts

Plug

Screws

Phone: [phone] | Fax: [phone] | Web: www.ledonedistribution.com | E-mail: [e-mail]

`

Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation operation or

maintenance.

Trunnion Mounting

CAUTION: UL and C-UL listed or CSA certified liquid tight
cord grip suitable for use with three conductor type STW
flexible cord shall be used for connection to a wet location
outlet box provided by others.
To adjust the angle of the fixture using the trunnion:

1. Loosen the Pivot Bolts & angle locking screw.

2. Adjust fixture to desired angle.

3. Tighten Pivot Bolts & angle locking screw.

Ground Mounting
Mount to a Mighty Post as shown.

1. Thread fixture into Mighty Post Cap.

2. Connect wires correctly.

3. Place Mighty Post Cap on the Mighty Post.

4.Aim floodlight in the direction desired and tighten
locknut and Arm Screw.

WIRING
Universal voltage driver permits operation at 120V to
277VAC, 50 or 60 Hz except fixtures factory ordered with a
(PC)

1. Connect the black fixture lead to the (+) LINE supply
lead.

2. Connect the white fixture lead to the (-) COMMON
supply lead.

3. Connect the GROUND wire from fixture to supply ground

CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough to
Touch. Do not clean or maintain while fixture is Energized.

1. Clean lens & fixture with non-abrasive glass cleaning
solution.

2. Do not open fixture to clean the LED. Do not touch the
LED.

Fig.1 Without photocell

Fig2. With photocell

TROUBLESHOOTING

1. Check that the line voltage at fixture is correct. Refer
to wiring directions.

2. Is the fixture grounded properly?

Flood

Mighty Post Cap

Mighty Post

Flood

Pivot Bolts