Page 1
MH11
MH11
18650
-
2.
<0.5s
2x
Hold 5s
Hold 5s
1.
2x Blink
+
4x Blink
1x
4x Blink
2x Blink
default setting
White RGBApp
O
1x
>10s
Boost
2s
O
=
Green
Yellow
Red
!
Ledlenser GmbH & Co. KG
Kronenstr. 5-7 • 42699 Solingen • Germany
Phone +49 212/5948-0 Fax +49 212/5948-200
info@ledlenser.com
ledlenser.com
MH11_V.01
12.11.2018
1J12A0266
Page 2
Hold 8s
MH11
Alteration
App
White Red/RGB
default setting
White Mode
Mode
1x
On
Hold 10s
Hold 12s
APP
Connect
APP
Disconnect
App Mode
O
1x
1x Blink
2x Blink
3x Blink
Memory Function
App Mode
White Mode
RGB Mode
(App /White /RGB )
1x
1x
>5s
O
RGB Mode
100%
Optisense
O
+1x
15%
Low
Power
+1x
>5s
+1x
Mid
Power
+1x
≤5s≤5s≤5s ≤5s
Power Blink
>5s
+1x+1x+1x
O
1x
+1x
+1x
≤5s ≤5s ≤5s
O Red Green Blue
+1x+1x
>5s
>5s
>5s
>5s
≤5s
+1x
>5s
+1x
4x Blink (white or RGB)
5V 1A
!
O!
1.
2.
Red
Green
Page 3
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition
without restriction.
Loading...