LEDGlow Single Color SMD LED Interior Lighting Kit User Manual

WARNING: DO NOT TURN ON OR CONNECT POWER TO THE CONTROL BOX

UNTIL ALL TUBES ARE PROPERLY CONNECTED

 Solid Illumination
 Left to Right Scan
 Flash Scan
 Alternating Side Scan
 Progressive Strobe
 Breath Mode
 Half and Half Strobe
 Progressive Strobe/Scan
 Slow Scan

 Fast Scan
 Alternating Side Scan
 Inside Out Scan
 Slow Strobe to Solid Illumination
 Alternating Strobe
 Left to Right Scan (Sound Activated)
 Left to Right Strobing Scan (Sound Activated)
 Inside Out Scan (Sound Activated)
 Inside Out Strobe (Sound Activated)

Single Color SMD Interior Lighting Kit

Warning: Please check your state and local laws before installing this kit. Each state has different policies and procedures in place for aftermarket vehicle accessories. LEDGlow is not
responsible for any fines that you may incur while using this interior kit. This kit is for off road use only.

Warning: LEDGlow recommends that this kit is installed by a licensed professional. Improper installation of this kit will void all warranties.

This kit is expandable, and the control box will power a total of 180 LEDs or 15 twelve inch strips

Please read the following instructions thoroughly before installing this kit.

1. Do a mockup of the way you are planning to install this kit into the interior of your vehicle, and test the kit prior to installation to ensure it is functioning properly.

2. Remove any trim pieces that may hinder the installation of the tubes on the vehicle. (Optional)

3. The included tubes feature two different wire lengths (5 feet and 9 feet) allowing them be installed virtually anywhere in your vehicle. Some good mounting locations are

under the dash in the foot well area, under the seat facing the foot well area, in the back seat or even inside of the trunk. When installing the interior tubes it is best to make
sure they are not visible which will give your interior a custom look.

NOTE: Output A and Output B located on the side of the control box are used to power the LED interior tubes. Use one or both of the outputs to power your
kit. Both of them do not have to both be used.

4. Start with the front tubes and mount them with plenty of clearance from any moving parts such as the steering shaft and/or pedals. Make sure the power wires are not near

the seat tracks or anything that may potentially cut or pinch the wires.

5. DO NOT SHORTEN OR CUT THE ANY OF THE INCLUDED WIRES, this will IMMEDIATELY void the warranty. This kit features USB connections

allowing them to be daisy chained together, and cannot be spliced if cut.

6. Find a safe and secure position to mount the control box. We recommend mounting the control box inside of your center console or inside of the glove box.

7. Connect the red power wire to a 12 volt power source. You can power this kit by running the red wire straight to the battery or by connecting it to your fuse block using

LEDGlow’s Expandable Circuit which is available online at www.LEDGlow.com.

 If you are running the power wire to the battery and going through the fire wall or any other metal parts, you must protect the wire by using an existing grommet or

by drilling a new hole in the firewall and adding a new grommet.

 For installation using LEDGlow’s Expandable Circuit use a multi-meter to locate a constant 12 volt fuse. Remove the stock fuse and install the expandable circuit

in its location. Re-install the original fuse into the slot located on the expandable circuit, and connect the red power wire.

 If you connect the power wire to a constant 12 volt source the kit will remember the last color and pattern it was on set on prior to the vehicle being turned off. This

kit will stay on until you turn it off. If you are connecting the power wire to a switched 12 volt power source this kit will not remember the last color and pattern

it was set on prior to the vehicle being turned off.

 If you need to extend the power wire be sure to use only 14 or 16 gauge automotive grade wire, and install a fuse within 6 inches of the power source. (Fuse is not

included if you have to extend the wires.)

 Connect the black wire to a good ground source on the vehicle. You can connect this ground wire directly to the battery, engine ground, or any bare metal source.

8. Re-Install any of the removed trim from step 2 and test the functionality of your new kit.

Controller Operation

 Button A: Power On/Off (Press and Hold for 2-3 Seconds)
 Button B: Modes

 Button C: Brightness Level
 Button D: Speed Function / Music Mode

Reprogramming the Wireless Remote

 5 Different Levels
 5 Different Speeds

1. Turn the kit off.

2. Press and hold any button on the wireless remote. While holding the button down on the wireless remote press the B button on the control box.

3. You will hear one tone if synchronization was successful. If you hear a multiple tones the synchronization did not work.

4. If synchronization was not successful, repeat steps one and two. If you still having problems synchronizing the wireless remote to the control box please contact our

Technical Support Department.

For accessories, replacement parts, and / or technical support please visit www.LEDGlow.com for more information.

ONE YEAR NON-TRANSFERRABLE LIMITED WARRANTY AND DISCLAIMER

LEDGlow Lighting, LLC ("LEDGlow") warrants to the original retail consumer purchaser, and not any other purchaser or subsequent owner, that this Product will be
free from defects in material or workmanship for a period of one (1) year from the purchase date. This warranty does not cover any Product that is (1) installed

incorrectly, or (2) damaged by collisions, vandalism, other accidents, or similar causes.

For a period of one (1) year from the date of purchase, at no charge to the Purchaser, LEDGlow will repair or replace this Product if it is determined by LEDGlow to
be defective. After the warranty period, the Purchaser must pay all charges for parts and labor.

Coverage under this warranty is only valid within the United States, including its territories, as well as in certain other countries. Purchasers should check our
website, www.LEDGlow.com, to determine the warranty coverage in the countries in which they are located.

LEDGlow does not warrant the installation of the Product, which is the sole responsibility of the Purchaser. Installation should be done by licensed professionals.
Improper installation may cause damage to the Product and any vehicle in which it is installed, and may cause burns and electrical injury to individuals. LEDGlow’s
warranty does not cover any expenses incurred in removing Products that are defective or re-installing replacement Products in their place.

During the warranty period, to have the Product repaired or replaced, the Purchaser must return the Product, freight prepaid by the Purchaser, to LEDGlow (but for
customers in the contiguous United States, LEDGlow will pay the shipping charges if any Product fails during the first thirty (30) days after purchase). The Product
must be returned in its original carton or in a similar package affording an equal degree of protection. LEDGlow will return the repaired or replaced Product, freight
prepaid, to the Purchaser. LEDGlow does not provide Purchasers with temporary replacement units during the warranty period or at any other time.

This limited warranty is non-transferrable and will automatically terminate if the original retail consumer purchaser resells the Product or transfers the vehicle on
which the Product is installed. An “original retail consumer purchaser” is a person who original ly purchases the Product, or a gift recipient of a new Product that is in
its original packaging and unopened.

This limited warranty is subject to all of the following terms and conditions:

1. NOTIFICATION OF CLAIMS; WARRANTY SERVICE: If Purchaser believes that a Product is defective in material or workmanship, written notice with an explanation of the claim
shall be given promptly by Purchaser to LEDGlow. All warranty claims must be made within the warranty period, and any Products returned to LEDGlow must be shipped in accordance with
LEDGlow’s procedures (including use of RMA numbers supplied by LEDGlow after notification). The repair or replacement of any Product or part thereof shall not extend the original warranty
period. The specific warranty on the repaired part only shall be in effect for a period of ninety (90) days following the repair or replacement of that part, or the remaining period of the Product
warranty, whichever is greater.

2. EXCLUSIVE REMEDY; ACCEPTANCE: Purchaser's exclusive remedy and LEDGlow's sole obligation is to supply (or pay for) all labor necessary to repair any Product found to be
defective within the warranty period and to supply new or rebuilt replacements for defective parts. LEDGlow will refund the purchase price for such Product only if repair or replacement fails to
remedy the defect. Purchaser's failure to make a claim as provided in paragraph 1 above or continued use of the Product shall constitute an unqualified acceptance of such Product and a waiver
by Purchaser of all claims thereto.

3. EXCEPTIONS TO LIMITED WARRANTY: LEDGlow shall have no obligation to Purchaser with respect to any Product that is subjected to any of the following: abuse, improper use,
negligence, accident, modification, failure to follow the operating procedures outlined in the user's manual, failure to follow the maintenance procedures in the service manual for the Product,
attempted repair by non-qualified personnel, operation of the Product outside of the published environmental and electrical parameters, or if the Product's original identification (trademark, serial
number) markings have been defaced, altered, or removed. LEDGlow excludes from warranty coverage Products sold AS IS and/or WITH ALL FAULTS. LEDGlow also excludes from
warranty coverage any consumable items such as fuses and batteries.

All software and accompanying documentation furnished with, or as part of the Product is furnished “AS IS” (i.e., without any warranty of any kind), except where expressly provided otherwise
in any documentation or license agreement furnished with the Product.

4. PROOF OF PURCHASE; REGISTRATION: The Purchaser's dated bill of sale must be retained as evidence of the date of purchase and to establish warranty eligibility. Registration of
any Product or of this limited warranty is voluntary, and failure to register will not diminish any rights available under this warranty.

EXCEPT FOR THE FOREGOING WARRANTIES, LEDGLOW HEREBY DISCLAIMS AND EXCLUDES ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT
NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR ANY WARRANTY WITH REGARD TO ANY CLAIM
OF INFRINGEMENT THAT MAY BE PROVIDED IN SECTION 2-312(3) OF THE UNIFORM COMMERCIAL CODE OR IN ANY OTHER STATE STATUTE.

THE LIABILITY OF LEDGLOW, IF ANY, AND PURCHASER'S SOLE AND EXCLUSIVE REMEDY FOR DAMAGES FOR ANY CLAIM OF ANY KIND WHATSOEVER,
REGARDLESS OF THE LEGAL THEORY AND WHETHER ARISING IN TORT OR CONTRACT, SHALL NOT BE GREATER THAN THE ACTUAL PURCHASE PRICE OF THE
PRODUCT FOR WHICH SUCH CLAIM IS MADE. IN NO EVENT SHALL LEDGLOW BE LIABLE TO PURCHASER FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES OF ANY KIND INCLUDING, BUT NOT LIMITED TO, COMPENSATION, REIMBURSEMENT OR DAMAGES ON ACCOUNT OF THE LOSS OF
PRESENT OR PROSPECTIVE PROFITS OR FOR ANY OTHER REASON WHATSOEVER.

GOVERNING LAW: This non-transferrable limited warranty shall be governed by the law of the State of New Jersey, U.S.A., and the United States of America, excluding their conflicts of laws
principles. The courts of Camden County, New Jersey, shall have the exclusive jurisdiction over any legal action with respect to this warranty.

This limited warranty gives specific legal rights. You may also have other rights that may vary from state to state or from country to country. Some states or countries do not allow the exclusion
or limitation of incidental or consequential damages, so the above limitations and exclusions may not apply to you. You are advised to consult applicable state or country laws for a full
determination of rights.

TERMS AND CONDITIONS

DISCLAIMER OF WARRANTY

LIMITATION OF LIABILITY