LEDGlow Million Color Mini SMD LED Interior Lighting Kit User Manual
WARNING: DO NOT TURN ON OR CONNECT POWER TO THE CONTROL BOX
UNTIL ALL TUBES ARE PROPERLY CONNECTED
Blue
Light Yellow
Red
Lime Green
Green
Violet
Pink
Ice Blue
White
Teal
Yellow
Deep Blue
Purple
Pale Green
Orange
Hot Pink
Light Purple
Dark Purple
Million Color Mini SMD-LED Expandable Interior Lighting Kit
Warning: Please check your state and local laws before installing the kit. Every state has different policies and procedures for aftermarket accessories. LEDGlow is not responsible for any fines that you may receive while
using the interior kit. This kit is for off road use only.
Warning: LEDGlow recommends this kit is installed by a licensed professional. Any damage to this kit that is the result of improper installation will void all warranties.
The Control Box must be installed in a dry location! Having this part exposed to water or the elements will cause the kit’s controller to fail. Any water damage or corrosion to this part will VOID all warranties.
Please read the following instructions thoroughly before installing your kit.
1. Arrange the tubes the way you plan to install them on the interior of the vehicle, and test the kit to ensure it is properly functioning before installing.
2. Remove any trim pieces from the interior of your vehicle that may hinder the installation of the tubes. (Optional)
3. Starting with the front tubes, mount them with plenty of clearance from any moving parts such as the steering shaft and pedals. Make sure the wires are not close to the seat tracks or anything that may
potentially cut or pinch the wires.
NOTE: Output A and Output B located on the side of the control box are used to power the LED interior tubes. Use one or both of the outputs to power your kit. Both of them do not have
to both be used.
4. Each interior tube can be mounted virtually anywhere in your vehicle. Some good locations are under the dash in the foot well area, under the driver and passenger seats facing the foot well area, under
the back of the driver and passenger seats facing in the back seat, or even in the trunk.
5. Find a safe, secure, and dry position to mount the control box. We recommend mounting the control box in your center console, under the seat, or in your glove box.
6. Connect the red wire to any 12 volt source. If you need to extend the power wires, be sure to only use a 14 or 16 gauge automotive grade wire. If you are connecting the red wire directly to your
battery, you must go through the fire wall. You need to protect the wire by using an existing grommet or by drilling a hole and adding a new grommet which is available at any auto parts store, and be
sure to install a fuse within 6 inches of the power source. (Fuse is not included if you have to extend the power wire.) If you connect the red wire to a switched 12v source it may not remember the
color and pattern your kit was on before the vehicle was powered off. You can avoid this problem by connecting the power wire to a constant 12 volt source. The kit will stay on until you turn it off
if it is connected to a constant 12 volt source. If you are powering your kit through the fuse block, LEDGlow recommends that you install the power wire using our add-a-circuit which is available
online at www.LEDGlow.com.
7. Connect the black ground wire to any good ground source on your vehicle. You can connect this wire directly to the battery or any engine ground.
8. DO NOT SHORTEN OR CUT ANY OF THE USB POWER WIRES. This will destroy the kit and void the warranty. LEDGlow offers 1, 3, 5, and 9 foot Mini USB power wires if you need a
longer wire to mount your interior tubes.
9. If you removed any interior trim for this light kit installation you can now reinstall them and test the functionality of your cut.
Controller Operation
Button A: Power On/Off (Press and Hold for 3 Seconds)
Button B: Modes
Button C: Color Change mode
Button D: Speed Function / Music mode
Reprogramming the Wireless Remote
1. Turn the kit off
2. Press and hold any button on the wireless remote. While holding the button down on the remote press the B button on the control box
3. If the sync was successful you will hear one beep, if it was not successful you will hear multiple beeps
4. If the sync was not successful repeat steps one and two. If you are having continued problems please contact our technical support department at 1.856.768.5700
Expandability Options
This 6pc Million Color Mini SMD-LED Expandable Interior Lighting Kit can be expanded to power a total of 72 SMD LEDs.
This control box can power an additional 18 SMD LED Interior Lighting Tubes.
o During operation press this button once to pause the current color changing function. Press it a second time to continue with the color change function.
Million color change (Color change option is not available on this mode)
Fade
Solid illumination (Speed Function is not available on this mode)
18 - Color change (Color change is option is not available on this mode)
Single Color Flashing
18 -Color Flashing (Color change option is not available on this mode)
SOS Flashing (Speed function and music mode is not available on this mode)
Demo (Changes thought the above functions every 15 seconds.)
o There are 5 speed levels
o Music mode
Press and hold the button for 3 seconds to activate music mode. (You will hear one beep when activating music mode)
Press and hold the button for 3 seconds to deactivate music mode. (You will hear two beeps when deactivating music mode)
For accessories, replacement parts, and / or technical support please visit www.LEDGlow.com for more information.
ONE YEAR NON-TRANSFERRABLE LIMITED WARRANTY AND DISCLAIMER
LEDGlow Lighting, LLC ("LEDGlow") warrants to the original retail consumer purchaser, and not any other purchaser or subsequent owner, that this Product will be free from defects in
material or workmanship for a period of one (1) year from the purchase date. This warranty does not cover any Product that is (1) installed incorrectly, or (2) damaged by collisions,
vandalism, other accidents, or similar causes.
For a period of one (1) year from the date of purchase, at no charge to the Purchaser, LEDGlow will repair or replace this Product if it is determined by LEDGlow to be defective. After the
warranty period, the Purchaser must pay all charges for parts and labor.
Coverage under this warranty is only valid within the United States, including its territories, as well as in certain other countries. Purchasers should check our website, www.LEDGlow.com, to
determine the warranty coverage in the countries in which they are located.
LEDGlow does not warrant the installation of the Product, which is the sole responsibility of the Purchaser. Installation should be done by licensed professionals. Improper installation may
cause damage to the Product and any vehicle in which it is installed, and may cause burns and electrical injury to individuals. LEDGlow’s warranty does not cover any expenses incurred in
removing Products that are defective or re-installing replacement Products in their place.
During the warranty period, to have the Product repaired or replaced, the Purchaser must return the Product, freight prepaid by the Purchaser, to LEDGlow (but for customers in the contiguous
United States, LEDGlow will pay the shipping charges if any Product fails during the first thirty (30) days after purchase). The Product must be returned in its original carton or in a similar
package affording an equal degree of protection. LEDGlow will return the repaired or replaced Product, freight prepaid, to the Purchaser. LEDGlow does not provide Purchasers with
temporary replacement units during the warranty period or at any other time.
This limited warranty is non-transferrable and will automatically terminate if the original retail consumer purchaser resells the Product or transfers the vehicle on which the Product is installed.
An “original retail consumer purchaser” is a person who originally purchases the Product, or a gift recipient of a new Product that is in its original packaging and unopened.
This limited warranty is subject to all of the following terms and conditions:
1. NOTIFICATION OF CLAIMS; WARRANTY SERVICE: If Purchaser believes that a Product is defective in material or workmanship, written notice with an explanation of the claim shall be given promptly by
Purchaser to LEDGlow. All warranty claims must be made within the warranty period, and any Products returned to LEDGlow must be shipped in accordance with LEDGlow’s procedures (including use of RMA numbers
supplied by LEDGlow after notification). The repair or replacement of any Product or part thereof shall not extend the original warranty period. The specific warranty on the repaired part only shall be in effect for a period of
ninety (90) days following the repair or replacement of that part, or the remaining period of the Product warranty, whichever is greater.
2. EXCLUSIVE REMEDY; ACCEPTANCE: Purchaser's exclusive remedy and LEDGlow's sole obligation is to supply (or pay for) all labor necessary to repair any Product found to be defective within the warranty
period and to supply new or rebuilt replacements for defective parts. LEDGlow will refund the purchase price for such Product only if repair or replacement fails to remedy the defect. Purchaser's failure to make a claim as
provided in paragraph 1 above or continued use of the Product shall constitute an unqualified acceptance of such Product and a waiver by Purchaser of all claims thereto.
3. EXCEPTIONS TO LIMITED WARRANTY: LEDGlow shall have no obligation to Purchaser with respect to any Product that is subjected to any of the following: abuse, improper use, negligence, accident,
modification, failure to follow the operating procedures outlined in the user's manual, failure to follow the maintenance procedures in the service manual for the Product, attempted repair by non-qualified personnel, operation
of the Product outside of the published environmental and electrical parameters, or if the Product's original identification (trademark, serial number) markings have been defaced, altered, or removed. LEDGlow excludes
from warranty coverage Products sold AS IS and/or WITH ALL FAULTS. LEDGlow also excludes from warranty coverage any consumable items such as fuses and batteries.
All software and accompanying documentation furnished with, or as part of the Product is furnished “AS IS” (i.e., without any warranty of any kind), except where expressly provided otherwise in any documentation or
license agreement furnished with the Product.
4. PROOF OF PURCHASE; REGISTRATION: The Purchaser's dated bill of sale must be retained as evidence of the date of purchase and to establish warranty eligibility. Registration of any Product or of this limited
warranty is voluntary, and failure to register will not diminish any rights available under this warranty.
EXCEPT FOR THE FOREGOING WARRANTIES, LEDGLOW HEREBY DISCLAIMS AND EXCLUDES ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO ANY
IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR ANY WARRANTY WITH REGARD TO ANY CLAIM OF INFRINGEMENT THAT MAY BE PROVIDED IN
SECTION 2-312(3) OF THE UNIFORM COMMERCIAL CODE OR IN ANY OTHER STATE STATUTE.
THE LIABILITY OF LEDGLOW, IF ANY, AND PURCHASER'S SOLE AND EXCLUSIVE REMEDY FOR DAMAGES FOR ANY CLAIM OF ANY KIND WHATSOEVER, REGARDLESS OF THE LEGAL
THEORY AND WHETHER ARISING IN TORT OR CONTRACT, SHALL NOT BE GREATER THAN THE ACTUAL PURCHASE PRICE OF THE PRODUCT FOR WHICH SUCH CLAIM IS MADE. IN NO
EVENT SHALL LEDGLOW BE LIABLE TO PURCHASER FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES OF ANY KIND INCLUDING, BUT NOT LIMITED TO,
COMPENSATION, REIMBURSEMENT OR DAMAGES ON ACCOUNT OF THE LOSS OF PRESENT OR PROSPECTIVE PROFITS OR FOR ANY OTHER REASON WHATSOEVER.
GOVERNING LAW: This non-transferrable limited warranty shall be governed by the law of the State of New Jersey, U.S.A., and the United States of America, excluding their conflicts of laws principles. The courts of
Camden County, New Jersey, shall have the exclusive jurisdiction over any legal action with respect to this warranty.
This limited warranty gives specific legal rights. You may also have other rights that may vary from state to state or from country to country. Some states or countries do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitations and exclusions may not apply to you. You are advised to consult applicable state or country laws for a full determination of rights.
TERMS AND CONDITIONS
DISCLAIMER OF WARRANTY
LIMITATION OF LIABILITY
Loading...