LEDGlow Advanced 3 Million Wheel Well Kit User Manual

Advanced 3 Million USB Flexible Wheel Well Add-On Kit

Warning: Please check your state and local laws before installing this LED wheel well lighting kit. Every state has different policies and

procedures in place regarding aftermarket vehicle accessories. LEDGlow is not responsible for any fines that you may receive while using the
underbody kit. This kit is for off road use only.

Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this kit will void all

warranties.

The Advanced 3 Million USB Extender Kit that connects the wheel well tubes to the USB control box must be installed in a dry location!
Having the extender kit exposed to water or the elements will cause it to fail. Any water damage or corrosion to this part will VOID all
warranties.

Kit Contents:
A. (4) 24” INCH EXTERIOR FLEXIBLE LED TUBES
B. (1) ADVANCED 3 MILLION USB EXTENDER KIT

Please read the following instructions thoroughly before installing this Advanced 3 Million USB Flexible Wheel Well Add-On Kit.

1. Arrange the tubes on the ground the way you plan to install them on the vehicle. Be sure to test the kit to ensure it

is functioning properly before installation.

2. Optional: Raise and support the vehicle if necessary, and remove the vehicle’s wheels.

3. Start with the driver’s side front tube. Mount the tube to your vehicle’s fender well above your tire using the

supplied screws. When mounting this tube make sure to keep it away from any moving parts or direct heat source.
Each wheel well tube is flexible and allows you to contour it directly to the fender well.

4. Complete the process explained in step 3 for the remaining wheel well tubes. Be sure to keep all wheel well tubes

and power wires away from any direct heat source or moving parts. NOTE: When installing the rear wheel well
tubes, make sure to keep each tube and their power wires at least 10 inches away from your exhaust.

5. If you removed your wheels in step 2, please reinstall them in accordance to factory specifications.

6. After you have installed all of the wheel well tubes, turn your steering wheel back and forth several times to

ensure there is enough clearance between your tire and each of the front tubes.

7. Find a secure and dry location to mount the USB extender kit. LEDGlow recommends mounting this inside the

vehicle close to your existing USB control box. The extender kit is not waterproof and cannot be mounted under
the hood. You will void the warranty if the extender kit is not mounted inside the cabin of the vehicle.

8. Connect the USB power wire that is included with the USB wheel well extender kit to any open port on the USB

extender kit that is powering your existing Advanced 3 Million Underbody Kit.

9. Starting with the rear tubes, run the power wires to the location of the USB extender kit. Make sure the power

wires are tightly secured when going around any suspension parts and the exhaust. Run and secure the power
wires along the upper section of the wheel well so there is no possibility of the wire falling onto the tire while the
vehicle is in motion. Make sure there is at least 10 inches between the exhaust or any direct heat source and the
power wires. Be sure not to pinch any of the power wires when running them, this kit may cause the kit to
malfunction and will void the warranty. Run the wires along the frame of the vehicle and make sure to tightly
secure them. Now run the front tube power wires to the extender kit location, again, keeping them away from any
moving parts or direct heat source.

10. It is extremely important to double check ALL of the power wires to ensure they are kept away from your wheel,

any moving parts, or direct heat source. Any excess or slack in the power wires will have to be bound up and
secured tightly.

11. DO NOT SHORTEN OR CUT ANY OF THE POWER WIRES. This will immediately void the warranty.

12. If your vehicle was raised you can now lower it. Power on the kit to ensure it is functioning properly.

13. With the vehicle on the ground, turn the steering wheel as far as it can go in both directions to ensure the tubes and

power wires do not come in contact with the tire. If a tube or wire is damaged by the tire due to improper

installation the warranty will be voided.

Limited Warranty and Disclaimer

All LEDGlow Lighting, LLC. products come with a one year limited warranty on the internal parts of the product. This warranty starts from the
date of purchase. LEDGlow Lighting, LLC. will replace or repair any qualifying defective product received by the company before the end of the
warranty period. Installation of this product must be performed by a licensed professional. Should the failure of the product be the result of
damage occurring as a result of improper installation, alteration of the product or an act or omission on the part of the consumer, this warranty is
void. LEDGlow Lighting, LLC. shall not be responsible for any consequential damages which arise from the use and/or installation of the
product. If the kit is installed in any manner other than specified, LEDGlow Lighting, LLC. reserves the right to deny any warranty claims at the
discretion of the technical support department. The one year warranty is not transferable and is valid for up to one year from the original date of
purchase. Any product return must include the original packaging, a statement of the alleged defect and an RMA number must be provided. All
RMA numbers are valid for 14 days from issued date. Upon receipt of the returned product, the company will test the product for defect. If the
results of the testing do not support the warranty claim, do not reveal any defect or indicate consumer negligence in the installation and handling
of the product, then the product will be returned to you and you will be charged a reshipping fee. If the product is returned from an address within
the continental United States, within the first 14 days after purchase, and is found to be defective, LEDGlow Lighting, LLC. will cover the cost of
the return shipping with an emailed return label. This offer is only valid for the continental US. All international shipping, customs fees and/or
duty charges are solely the responsibility of the consumer.

Additional Disclaimer Terms

Lights are for off road use only; please check your local and state laws for the proper use of this product.

· Improper installation of electricity-using products such as lighting may cause damage to any vehicle or device to which the improperly handled
or installed lighting is attached.

· Improperly installed product may cause electrical injury to persons.

· It is recommended that the kit be installed by a licensed professional.

· LEDGlow Lighting, LLC. assumes no liability for the installation of the product.

· Warranty or liability will not exceed the product purchase price which shall be the buyer’s sole and exclusive remedy.

THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE WARRANTIES DESCRIBED ON THE FACE HEREOF INCLUDING
ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. (LEDGlow Lighting, LLC. AT

IT’S DISCRETION, MAY PROVIDE REMEDY OF RETURN OF PURCHASE PRICE OR REPAIR OR REPLACEMENT OF DEFECTIVE

PRODUCT AS BUYERS SOLE AND EXCLUSIVE REMEDY.)

LEDGlow Lighting, LLC.

150 Cooper Road - Suite A-2 West Berlin, NJ 08091