Ledco Easy RGB(Y) User Manual
1
Easy RGB(Y) Remote controller User Manual
1. Product introduction
Easy RGB(Y) remote controller is a wireless color control system that
consists a sender and a receiver or several receivers, as shown in Figure 1, 2:
By selecting switch status, you can set the system as RGB 3-channel
output, or RGBY 4-channel output. Using Easy RGB(Y) remote controller,
you can get whatever color you want; you can choose any color from RGB(Y)
to adjust so as to mix more than 100 million kinds of colors. With built-in 10
kinds of color changing modes, you can easily switch color changing modes
and adjust speed and brightness. “Function Pause” enables RGBY LED to stay
at your favorite color under the situation of color changing modes, which
operation is simple but functional.
Three working frequencies are available: 434MHZ，868MHZ or
915MHZ,which are suitable for Europe, Americas and elsewhere in the
world .All products completely comply with European CE regulations and
American FCC regulations.
Fig.1
2
Fig.2
2. Performance parameters
2.1 Sender: (model:SR-2806)
Working temepature:4.5V(3×1.5V 7 AAA battery)
Working current：＜22mA
Dormancy current：＜20μA
Working frequency：434MHZ/868MHZ/915MHZ (optional)
Transmit power ：≥5dBm
2.2 Receiver (model：SR-1003RC/SR-1012RC/SR-1022RC model)
Input Voltage：12-36VDC
Output Voltage：12-36VDC
Input Current：4CH×3A max (SR-1003RC)
4CH×350mA (SR-1012RC)
4CH×700mA (SR-1022RC)
Output power：4CH×(36-108W) max (SR-1003RC)
4CH×(4.2-12.6W) (SR-1012RC)
4CH×8.4-25.2W) (SR-1022RC)
Working Frequency：434MHZ/868MHZ/915MHZ (optional)
3. components description：
3.1 Sender (model：SR-2806)
“ R” button and indicator。
3
“G” button and indicator。
“B” button and indicator。
“Y” button and indicator。
Working status indicator, the sender is in dormant status when the indicator is
off. The sender is under working when the indicator is flashing rapidly. If the
indicator continues flashing at the frequency of 1 second, it indicates that the
sender batteries low and needs to replace new batteries.
Slow down the speed when color is changing
Speed up when color is changing.
Multifunction button, used for selecting, Synchronous or asynchronous
mode.
Brightness down
Brightness up
Multifunction button, used for turn ON/OFF and white output .
Figure 1-10 is for selecting receiver’s ID and ID itself to turn
ON/OFF.
4
Touch wheel for selecting R/G/B colors.
3.2 Receiver (Model:-1003RC/SR-1012RC/SR-1022RC)
J1---power input socket
J2---RGB(Y) output socket
J3—RGB/RGBY output switch, closed circuit is RGB 3
channel output, open circuit
is RGBY 4 channel
output.
Receiver ID code learning Button
Receiver ID code learning indicator and for receiving message
4. Basic Usage
4.1 Install battery
Initial using easy RGB(Y) remote controller, open the battery cover on the
back of the sender, load 3pcs 7 AAA (1.5V) batteries. Please pay attention to
the battery’s negative and positive, otherwise it will fail to work.
5
Loading...