Lectrosonics WMBCSL, WMBCWIRE Data Sheet

WM Belt Clips

WMBCSL

Spring-Loaded Metal

• Machined Aluminum Bracket

• Machined Aluminum Spring-Loaded Clip

The spring-loaded machined aluminum clip has the same
type of attachment collar as the wire clip, and installs in
the very same manner, but provides better retention than
the wire clip.

WMBCWIRE

Stainless Steel Wire

• Machined Aluminum Bracket

• Stainless Steel Spring Clip

The spring wire belt clip allows the transmitter to be worn
on a belt or other wardrobe item where a low profile is
required.

Installation Instructions

The housing on
dual battery models
is symmetrical, so
the bracket can be
positioned on either
the top or bottom of the
transmitter to orient the
antenna accordingly.

Detents are provided in
the back cover to align
with the set screws in the
belt clip.

Detents

Hardware for WM transmitter models

P/N 28832 set screw

P/N 26862

thumb screw

P/N 35856 1/16 in.

(.0625 in.) hex key

(allen wrench)

Thumbscrews Set Screws

Align the bracket so the set screw seats into the detent
and tighten it with the hex key. Do not overtighten the set
screw.

The belt clip can be installed so you have the antenna
up or the antenna down. The WM belt clip, however, will
only slide on to the transmitter on the top side where
the antenna is mounted. Belt clip will not fit over battery
doors

Each belt clip comes with a set of thumscrews and a set
of set screws for you to mount per your preference. Hex
keys (Allen Wrenches) are also included for set screw
installations

581 Laser Road NE • Rio Rancho, NM 87124 USA • www.lectrosonics.com
[phone] • [phone] • fax [phone] • [e-mail]

16 January 2013