Lectrosonics SMDWBBCSL, SMWBBCDNSL, SMWBBCUP, SMWBBCUPSL, SMWBBCDN Data Sheet

SMWB Series Belt Clips

Stainless Steel Wire Kits Spring-Loaded Metal Kits

• Machined Aluminum Bracket

• Stainless Steel Spring Clip

The spring wire belt clip allows the transmitter to be worn
on a belt or other wardrobe item where a low profile is
required. Three models are available:

SMWBBCUP

For single battery
transmitter. The
antenna points
UP when the
transmitter is worn
on a belt.

SMWBBCDN

For single battery
transmitter. The
antenna points
DOWN when the
transmitter is worn
on a belt.

• Machined Aluminum Bracket

• Machined Aluminum Spring-Loaded Clip

The spring-loaded machined aluminum clip has the same
type of attachment collar as the wire clip, and installs in
the same manner, but provides better retention than the
wire clip. Three models are available:

SMWBBCUPSL

For single battery
transmitter. The
antenna points UP
when the transmitter
is worn on a belt.

SMWBBCDNSL

For single battery
transmitter. The an­tenna points DOWN
when the transmitter
is worn on a belt.

SMDWBBC

For dual-battery
transmitter. Can be
used with antenna
up or down.

Hardware part numbers

P/N 28832 set screw

thumb screw

SMDWBBCSL

For dual-battery
SM Series transmit­ter. Can be used with
antenna up or down.

P/N 35856 1/16 in.

(.0625 in.) hex key

(allen wrench)

P/N 26862

Installation Instructions

m

Single Battery Model

Two detents in the flat side
of the housing align the belt
clips. The antenna UP version

Detent

ANT UP

Detent

ANT DOWN

Align the set screws with the detents in the back cover,
and tighten them with the supplied hex key until they are
snug.

Do not overtighten the set screws.

is shown. Align the bracket so
the set screw seats into the
detent and tighten it with the
hex key. Do not overtighten
the set screw.

NOTE: Early single battery
models did not have
detents, so the bracket must
be aligned manually.

Hex key

Note: Installation is the same for both the

wire clips and the spring-loaded clips.

Spring loaded

belt clip on single

battery model

mounted with

thumbscrew

Dual Battery Model

The housing on dual bat­tery models is symmetri­cal, so the bracket can
be positioned on either
the top or bottom of the
transmitter to orient the
antenna accordingly.

Detents are provided in
the back cover to align
with the set screws in the
belt clip.

Detents

On the antenna down

version, make sure the

bracket is positioned to

allow the battery door

to swing open

581 Laser Road NE • Rio Rancho, NM 87124 USA • www.lectrosonics.com
[phone] • [phone] • fax [phone] • [e-mail]

When the bracket is

mounted on this end,

make sure the bracket

is positioned to allow

the battery door to

swing open

21 November 2017