Lectrosonics LRSHOE Data Sheet

LRSHOE

Receiver Mount Kit

TECHNICAL DATA

11 November 2014

Cold Foot Mount

Part# 26752

Thumb Nut

Part# P1241-1

The LRSHOE kit is supplied with the parts
needed to mount the LR receiver on a camera
or DSLR accessory bracket.

1

Thread the stud into the

tensioning nut about 1-2

turns, then rotate it to orient

the receiver control panel

in the desired direction.

Tighten the jam nut to keep

the shoe from rotating.

Washer

Part# 28912

LRSHOE-MO

Assemble the parts as shown. The nut in the bracket is an elliptical
tensioning type. A wrench is needed to insert the cold foot stud.

3

Jam Nut

Part# 28898

The belt clip wire

seats into grooves

on the shoe mount.

Slide shoe mount under the belt clip as shown.

2

To attach belt clip align with
holes on each side of unit
(the belt clip is not included
in the LRSHOE kit).

581 Laser Road NE • Rio Rancho, NM 87124 USA • www.lectrosonics.com
[phone] • [phone] • fax [phone] • [e-mail]

4

LR mounted to camera using LRSHOE.