Lectrosonics LRBATELIM Datasheet

LRBATELIM

Battery Eliminator

TECHNICAL DATA

This battery eliminator replaces the batteries and door
on the LR receiver, allowing the unit to be powered from
an external DC source. The battery eliminator is supplied
in a kit including mounting screws.

P/N 28615 (2-56 1/8 FL100)P/N 28623 (2-56 5/16 FL100)

Removing the Battery Door

Insert the battery eliminator as shown below and fasten
it with the supplied screws.

P/N 29623 (2-56 5/16

FL100) screws

CAUTION: Use only the shorter screw P/N
28615 (2-56 1/8 in.) in the hole near the
connector. The longer screws may damage a
circuit board component.

Tighten all three screws snugly, but be careful not to
overtighten them and damage the threads.

P/N 28615 (2-56 1/8

FL100) screw

Remove

these

screws

Save the door
assembly parts for
re-installation later

Optional power cables from Lectrosonics include:

P/N 21746 right angle, locking cable; 12 in. length

P/N 21747 right angle, locking cable; 6 ft. length

Rio Rancho, NM, USA
www.lectrosonics.com

m

Replacing the Battery Door

Separate part numbers for the battery door assembly are
as follows.

NOTE: The insulator, shorting bar and batt door
are factory assembled with an adhesive.

P/N 26986

latch plate

P/N 28623
2-56 5/16”

P/N P1293

insulator

P/N 28615

2-56 1/8”

P/N 26896

shorting bar

P/N 27033

spring detent

Assemble the battery door and latch plate.

P/N 26985

batt door

Place the spring detent clip on the housing with the tabs
facing upward and the screw hole aligned with the one in
the housing.

Tabs

Align holes

Mount the latch plate and door assembly on top of the
spring detent and align the screw hole. Insert the short­est screw (P/N 28615 2-56 1/8” into the hole and tighten.

CAUTION: Use only the 1/8” screw. The longer
ones may damage the circuit board inside.

As you tighten the screw, the latch plate and door pivot
will align the spring detent. Tighten the screw snugly, but
not so tight it damages the threads.

Make sure spring

tabs are on the

outside of the

door pivot

Close the door and make sure it latches correctly. If so,
then insert and tighten the two screws on the outside of
the housing. Use the longest screws (P/N 28623 2-56
5/16”).

Tighten the two

screws on the

outside of the

housing.

Specifications

Input voltage range: 5 to 25 VDC
Dimensions: 53 x 60 x 21 mm (2.09 x 2.38 x .84 inches)
Weight: 23 grams (0.81 ozs.)

Locking collar with

5/16”-32 thread

Mating connector

dimensions

.475” O.D.

581 Laser Road NE • Rio Rancho, NM 87124 USA • www.lectrosonics.com
[phone] • [phone] • fax [phone] • [e-mail]

15 June 2015