
HM142V/HM152V
Headset Microphones
Feature Highlights
• Worn over the head or around the neck
• Omni-directional element & adjustable mic boom for
maximum gain and minimum wind noise
• Adjustable headband cushions
• Built in volume control
• Rugged construction for long life
HM142V
TECHNICAL DATA
The HM142V & HM152V headset microphones are a lightweight design for use with a wide variety of Lectrosonics
wireless PA, microphone and IFB systems. The stainless
steel headband and boom are adjustable for maximum
comfort and flexibility.
The foam temple pads are attached to machined aluminum assemblies clamped to the headband. The position
of the temple pad opposite the mic boom is adjustable for
a comfortable, secure fit. The stainless steel headbands
are simply shaped by hand to fit the head.
The units are the same except for the headband design.
The pickup capsule is an omnidirectional electret type,
powered by a DC bias present on the input jack of Lectrosonics transmitters. The omni-directional capsule
provides a wide, flat frequency response, plus ultra low
wind noise and clothing “rattle.”
HM152V
The stainless steel microphone boom is mounted in a ball
joint to allow adjustment to position the microphone to the
left and slightly away from the mouth.
The volume control on the temple pad is used to temporarily control feedback when used with a sound system.
Both models are available with a locking micro plug, TA5F
5-pin plug, or standard 3.5mm mini plug for use with Lectrosonics wireless transmitters.
Rugged machined aluminum and stainless steel are used
to construct the headset for years of heavy use.
Rio Rancho, NM, USA
www.lectrosonics.com