Lectrosonics HM142V User Manual

HM142V

Headset Microphones

Feature Highlights

• Worn over the head or around the neck

• Omni-directional element & adjustable mic
boom for maximum gain and minimum wind

noise

• Adjustable headband cushions

• Built in volume control

• Rugged construction for long life

TECHNICAL DATA

HM142V

The HM142V headset microphones are a lightweight
design for use with a wide variety of Lectrosonics wire­less PA, microphone and IFB systems.The stainless steel
headband and boom are adjustable for maximum comfort
and flexibility.

The foam temple pads are attached to machined alumi­num assemblies clamped to the headband. The position
of the temple pad opposite the mic boom is adjustable for
a comfortable, secure fit. The stainless steel headbands
are simply shaped by hand to fit the head.

The pickup capsule is an omnidirectional electret type,
powered by a DC bias present on the input jack of Lec­trosonics transmitters. The omni-directional capsule
provides a wide, flat frequency response, plus ultra low
wind noise and clothing “rattle.”

The stainless steel microphone boom is mounted in a ball
joint to allow adjustment to position the microphone to the
left and slightly away from the mouth.

The volume control on the temple pad is used to temporar­ily control feedback when used with a sound system.

Available with a locking micro plug, TA5F 5-pin plug, or
standard 3.5mm mini plug for use with Lectrosonics wire­less transmitters.

Rugged machined aluminum and stainless steel are used
to construct the headset for years of heavy use.

Rio Rancho, NM, USA
www.lectrosonics.com