Lectrosonics FMAKM2T Data Sheet
FMAKM2T
M2T Antenna Kit
TECHNICAL DATA
Kit includes:
• (2) antenna cables
• (2) sealing washers, red
• (2) locking rings
The M2T transmitter occupies a half rack space, and
comes with hardware to mount two (2) M2T transmitters into a rack. RMPM2T-1, a single rack mount kit, is
also available. You will need the hardware that comes
with these mounting kits to attach the FMAKM2T.
• (2) flat nuts
• (1) grommet
1. Begin by
removing the
flat nut, red
sealing
washer and
locking ring
(under red
sealing
washer) from
both cables.
4. Attach antenna cable input into the back of
the M2T.
5. Repeat steps 1-4 on other side of M2T.
6. The grommet is
needed if you are
only mounting a
single M2T unit into
a rack, using the
single rack mount kit
(RMPM2T-1). Cut
through the grommet so you can
place it around the
antenna cable.
7. The grommet then fits inside the support bracket
flange (Part #27076) as shown below. Orient your cut
to face inside the support bracket slot.
2. Replace only the red sealing washer on each cable.
(Use a small screwdriver to accurately secure the
red sealing washer.)
3. Insert the antenna cable hardware into the mounting bracket in the following order:
Antenna cable
Mounting bracket
Red sealing
washer
Locking ring
Flat nut
Support
bracket
Grommet
Rio Rancho, NM, USA
www.lectrosonics.com
29 November 2017
Loading...