Lectrosonics AMJ19 Datasheet
AMJKIT Rev. A
AMJ KIT CUTTING TEMPLATE
TECHNICAL DATA
Jointed Whip Antenna
The AMJ antenna is a general purpose design for any
Lectrosonics receiver or transmitter with a standard SMA
connector. The hinged joint pivots in both directions for
positioning the whip at any desired angle.
Lay uncut antenna on this template and cut to length for the desired frequency block
Whip Length
*Cut end of cap off
and slide over whip
Tr im the end of the color cap and slide the remaining sleeve over the whip - OR - Glue color cap onto the end
Note: Check the scale of your printout. This line should be 6.00 inches long (152.4 mm).
944
12 July 2016
470
30
31
28
29
32
33
26
27
Frequency Blocks
23
24
25
21
22
20
19
*Color cap
BLOCK FREQUENCY CAP/SLEEVE ANTENNA
RANGE COLOR WHIP LENGTH
470 470.100 - 495.600 Black w/ Label 5.56” 141.2 mm
19 486.400 - 511.900 Black w/ Label 5.27” 133.9 mm
20 512.000 - 537.500 Black w/ Label 4.93” 125.2 mm
21 537.600 - 563.100 Brown w/ Label 4.71” 119.6 mm
22 563.200 - 588.700 Red w/ Label 4.48” 113.8 mm
23 588.800 - 614.300 Orange w/ Label 4.27” 108.5 mm
24 614.400 - 639.900 Yellow w/ Label 4.07” 103.4 mm
25 640.000 - 665.500 Green w/ Label 3.87” 98.3 mm
26 665.600 - 691.100 Blue w/ Label 3.68” 93.5 mm
27 691.200 - 716.700 Violet (Pink) w/ Label 3.52” 89.4 mm
28 716.800 - 742.300 Grey w/ Label 3.36” 85.3 mm
29 742.400 - 767.900 White w/ Label 3.22” 81.8 mm
30 768.000 - 793.500 Black-w/Label 3.08” 78.2 mm
31 793.600 - 819.100 Black-w/Label 2.97” 75.4 mm
32 819.200 - 844.700 Black-w/Label 2.89” 73.4 mm
33 844.800 - 865.000 Black-w/Label 2.81” 71.4 mm
944 944.100 - 951.900 Black-w/Label 2.53” 64.3 mm
The hinged joint pivots in both directions
NOTE: Disconnect antennas from
equipment for storage and transport.
25 lbs. of lateral force near the hinge
pin can break the center pin.
Rio Rancho, NM, USA
www.lectrosonics.com
Loading...