Lebensstil Kollektion VOLCANO Series, LKGH-8602MB, LKGH-8603MB Instruction Manual
VOLCANO GAS HOB
Instruction Manual
LKGH-8602MB
LKGH-8603MB
www.lebensstilkollektion.com
Table of Contents
Components and features
Description of the appliance
Using the gas hob
Maintenance
Practical Advice
Safety
Troubleshooting
Installation instructions
1234568
9
1
Components and Features
A. Wok burner
B. Support Grid for Cookware
C. Control Knobs for Gas Burners
D. Ignition for Gas Burners
E. Safety Device
F. Energy gathered pan
G. Auxiliary burner
2
Description of the appliance
This built in gas hob is supplied with 2 burners(LKGH-8602MB) or 3
burners(LKGH-8603MB) on a glass panel. Each burner is operated by a FSD/
plug type gas valve, controlled by a metal control knob positioned on the top of
the panel. Each burner is fitted with a flame safety device. The appliance uses
a battery supply of 1.5V DC that operates the ignition system.
Burner
Injector
size(mm)
Injector
marking
Full rate
kW
For LPG
Wok
Inner ring
0.6
60
5.5kW
Outer ring
0.9
90
Auxiliary
/
0.6
60
1.5kW
Model number
Burner Variants
Wok burner
Auxiliary burner
Total
Dimensions
LKGH-8602MB
2
0
11.0kW
（860×500）mm
LKGH-8603MB
2
1
12.5kW
（860×500）mm
Note:Wok burner=Rated at 5.5kW
3
Using the gas hob
The position of the corresponding gas burner is indicated on each control knob.
Gas Burners
Choose appropriate diameter of the cookware being used.
The diameter of the cookware used should be larger than the burners in order
to save energy. Always make sure that your pans are placed centrally on the
burners and do not allow the flame to extend over the base of the pan.
The burner can be regulated with the corresponding control knob by using one
of the following settings:
To turn on the burner
Please press the corresponding knob all the way down and turn it in the
counter-clockwise direction to the “high” setting.
Keep the knob press down for approximately 3 seconds to allow the safety
device to heat up.
To turn off the burner
Turn the knob in the clockwise direction until it stops (at “●” setting).
Should the cooktop be installed directly under a cupboard, it should be at least
720 mm (millimeters) from the top, as shown in Fig. C.
The dimensions of the cutout for the appliance must be those indicated in the
Fig D. Clamps are provided to fasten the cooktop to counters measuring from
20 to 60 mm in thickness. To fasten the cooktop securely, it is recommended
that all the clamps be used.
Caution: If the burner goes out accidentally, turn off the gas with the control
knob and try to light it again after waiting for at least 1 minute.
Loading...