Model NOR-66349-PK Single Pedestal Desk
Parts Listing
B
Side Panel Legs
2 Units
D
Privacy Panel
1 Unit
G
6x55mm Screw
4 Units
A
Desk Top
1 Unit
Pedestal
1 Unit
E
Drawer Runners
2 Units
H
10x35mm Screw
4 Units
6x16mm Screw
C
F
Drawer
1 Unit
10 Units
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
back
front
1
L
J
H
B
2
A
E
E
I
3
I
4
I
C
Tools Supplied: Allen Wrench, Phillips Head Screw Bit
Please read all instructions before assembly. Assembly will require 2 people and
should be done in place.
Step 1: Align Side Panel Legs (B) with the support rail on the underside of the
Desk Top (A). Place Corner Leg Bracket (L) in holes on support rail, and insert
10x35mm Screw (H) through bracket and into legs. Tighten using Allen Wrench (J).
Align Drawer Runners (E) with holes in underside of the Desk Top (A).
Attach using 6x16mm Screws (I) and Phillips Head Screw Bit (K).
Step 2: Attach Pedestal (C) to underside of Desk Top (A) by aligning screw holes
in Pedestals with holes in Desk Top, and inserting 6x55mm Screws (G)
to secure, one in each corner of the pedestal. Tighten using Phillips Head
Screw Bit (K) or screwdriver.
G
B
C
A
I
K
D
C
Be sure to remove the Pedestal drawers prior to installation.
Step 3: Attach Pedestal (C) to Side Panel Legs (B) by inserting
6x16mm Screws (I), two in each leg, through
pedestal wall and into legs. Tighten using Phillips
Head Screw Bit (K) or screwdriver.
Step 4: Attach Privacy Panel (D) to Pedestal (C) by inserting two
6x16mm Screws (I) through side of Privacy Panel (D)
and into the side of Pedestal (C). Attach Privacy Panel (D)
to Side Panel Legs (B) by inserting two 6x16mm
Screws (I) through other side of Privacy Panel (D) and
into the corresponding hole on the inside of the Side
Panel Leg (B). Tighten using Phillips Head Screw Bit (K).
Step 5:
side up using at least two
5
F
people. Insert the Drawer (F)
backwards, as shown,
aligning it with the Drawer
Runners (E). Push Drawer
(F) all the way in to secure.
Note: At this time you can
insert drawers back into the
Pedestal (C) and push all the
way in to secure.
Flip the desk right
J
Allen Wrench
1 Unit
K
Phillips Head
Screw Bit
1 Unit
L
Corner
Leg Bracket
4 Units
Assembly Notes:
During assembly, loosely tighten screws only. When all
screws are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this desk as a step ladder.
2. Check for loose screws and tighten them every 6 months.
02.13.2017
3736 Regent Avenue
Cincinnati, OH 45212
800.260.2776 schooloutf itters.com
Loading...