Learning Resources LER 4403 User Manual

LER 4403
Easi-Speak™ Sound Station User Guide
Easi-Speak™ Sound Station User Guide
Easi-Speak™ Sound Station User Guide
Easi-Speak™ Sound Station User Guide
Easi-Speak™
Sound Station
Please Read All Instructions Carefully Before Using
User Guide
•   Please retain these instructions for future reference
•   Sound Station contains a rechargeable NiMH  battery pack
•   Do not attempt to remove the battery 
•   The external charger must be regularly examined for  potential hazard, such as damage to the cable or cord,  plug, enclosure or other parts. If such damage occurs,  do not use the Sound Station until that damage has  been fixed properly 
•   Only charge rechargeable batteries under adult  supervision
•   Do not short-circuit the supply terminals 
•   Do not allow your Sound Station to come into contact  with water or other liquids
•   In the event of an electro-static discharge, your Sound  Station may malfunction. In this case, you may need to  turn it off to reset it
•   Warranty is void if the case is opened for any reason
•   The warranty does not cover any data loss from the 
Easi-Speak
 unit nor any consequential loss of 
information
2
FCC compliance
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY R ADIO 
OR TV INTERFERENCE CAUSED BY UNAUTHORIZED  MODIFICATIONS TO THIS EQUIPMENT. SUCH  MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO  OPERATE THE EQUIPMENT.
NOTE: This equipment has been tested and found to comply  with the limits for a Class B digital device, pursuant to Par t  15 of the FCC Rules. These limits are designed to provide  reasonable protection against harmful interference in a  residential installation. This equipment generates, uses and  can radiate radio frequency energy and, if not installed and  used in accordance with the instructions, may cause harmful  interference to radio communications. However, there is no  guarantee that interference will not occur in a particular  installation.
If this equipment does cause harmful interference to radio  or television reception, which can be determined by turning  the equipment off and on, the user is encouraged to try to  correct the interference by one or more of the following  measures:
•   Reorient or relocate the receiving antenna 
•   Increase the separation between the equipment and  receiver 
•   Connec t the equipment into an outlet on a circuit  different from that to which the receiver is connected 
•   Consult the dealer or an experienced radio/ TV technician  for help
Know Your Sound Station
Using Your Sound Station
The Easi-Speak™ connects to the Sound Station via the 
Power LED
On/off volume
Stereo speakers
Jack plug – connects to headphone  socket on your Easi-Speak
headphone output socket. With the USB cap in place,  turn the Easi-Speak the jack plug on the Sound Station and push it into  place. Turn the Sound Station on and press the 
Easi-Speak
volume control to the desired level. It may be necessary  to increase the Easi-Speak achieve the best results (the volume controls are not  accessible once the Easi-Speak
Power LED
The power LED is illuminated whenever the Sound 
 until the headphone socket faces 
 play button, then adjust the Sound Station 
 volume, before docking, to 
 is docked).
Station is turned on. When not in use, turn your Sound  Station off by rotating the volume switch until you hear  a “click” and the red power light turns off.
Charging the Battery
Line-in socket
6 Headphone  sockets
D.C. socket for  external charger
3
4
Sound Station is supplied with a partially charged  battery and can be used immediately without charging  first. The battery can be charged by connecting the  external power supply to the power input.
•   Even when the battery is fully discharged, Sound  Station will operate normally when the external  power supply is connected. The battery will also be  charging at this time.
5
Easi-Speak™ Sound Station User Guide Easi-Speak™ Sound Station User GuideEasi-Speak™ Sound Station User Guide Easi-Speak™ Sound Station User Guide
•   A complete charge of a fully discharged battery will  take about 24 hours. The Sound Station is intended to  be permanently left on charge so that it is always  ready for use. 
Technical specification
•   Built-in 1300mAH NiMH battery
•   Total Harmonic Distortion+Noise 0.3% (Typ)
•  Six stereo 3.5 mm headphone sockets (green)
•   One stereo 3.5 mm line-in socket (pink),  100mV RMS Max
•   Batter y life approx. 3 hours (depends on volume  setting and type of audio)
Troubleshooting
Sound Station is designed to work reliably and  predictably in all normal conditions. However, it is  possible that problems may occur. Please check the  following before contacting technical support:
Problem Power LED appears dim
Solution Battery is low. Charge the battery. Sound 
Problem Power LED doesn’t come on
Solution Battery completely flat; recharge
Problem Sound is too quiet
Solution The Easi-Speak
Station can be used while charging
 recording is very quiet. 
Increase the Easi-Speak
 volume setting 
Support & Warranty
This product is provided with a one-year warranty for  problems found during normal usage. Mistreating the  Sound Station or opening the unit will invalidate this  warranty. Any data stored on the Easi-Speak consequential loss is not covered by this warranty. The  battery is not user replaceable.
All out-of-warranty repairs will be subject to a  replacement fee.
Please visit www.LearningResources.com for the latest  product information and technical support.
Easi-Speak
 is a registered trademark of TTS Group Ltd.
 and any 
This device complies with Part 15 of the FCC Rules.  Operation is subject to the following two conditions:  (1) This device may not cause harmful interference, and  (2) This device must accept any interference received,  including interference that may cause undesired  operation.
Warning: Changes or modifications to this unit not  expressly approved by the party responsible for  compliance could void the user’s authority to operate  the equipment. 
before docking
Problem Sound is distorted
Solution Reduce the Sound Station volume until the 
sound is free from distortion.
6 87 9
©  Learning Resources, Inc., Vernon Hills, IL (U.S.A.)   Please retain our address for future reference.   Made in China.       LRM4403-GUD
  Fabriqué en Chine.  Informations à conserver.   Made in China.  Bitte bewahren Sie unsere      Adresse für spätere      Nachfragen auf.   Hecho en China.  Conservar estos datos.
Visit our website to write a product review  or to nd a store near you.
Loading...