Learning Resources LER 3774 User Manual

Liven up any game by using these

buzzers with four fun sounds!

LER 3774

Battery Information

Installing or Replacing Batteries

WARNING! To avoid battery leakage, please follow these instructions carefully. Failure to follow these instructions can result in battery acid leakage that may cause burns, personal injury, and property damage.

Requires: 2 x 1.5V AAA batteries and a Phillips screwdriver

• Batteries should be installed or replaced by an adult.

• Answer Buzzers require (2) two AAA batteries each.

• The battery compartment is located on the bottom of the unit.

• To install battery, first undo the screw with a Phillips screwdriver and remove the battery-compartment door. Install batteries as indicated inside the compartment.

• Replace compartment door and secure with screw.

Battery Care and Maintenance Tips

• Use (2) two AAA batteries.

• Be sure to insert batteries correctly (with adult supervision) and always follow the toy and battery manufacturer’s instructions.

• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.

• Do not mix new and used batteries.

• Insert batteries with the correct polarity. Positive (+) and negative (-) ends must be inserted in the correct directions as indicated inside the battery compartment.

• Do not recharge non-rechargeable batteries.

• Only charge rechargeable batteries under adult supervision.

• Remove rechargeable batteries from the toy before charging.

• Only use batteries of the same or equivalent type.

• Do not short-circuit the supply terminals.

• Always remove weak or dead batteries from the product.

• Remove batteries if product will be stored for an extended period of time.

• Store at room temperature.

• To clean, wipe the surface of the unit with a dry cloth.

• Please retain these instructions for future reference.

Information to User NOTE: This equipment has been tested and found to comply within the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or experienced radio/TV technician for help.

NOTE: Changes or modifications not expressly approved by the party for compliance could void the user’s authority to operate the equipment.

Learning Resources Ltd., King’s Lynn, Norfolk (U.K.) Please retain our address for future reference. Made in China. LRM3774-GUD

Fabriqué en Chine. Informations à conserver.

Visit our website to write a product review or to find a store near you.

Made in China. Bitte bewahren Sie unsere

Hecho en China. Conservar estos datos.

Adresse für spätere Nachfragen auf.