LEAPAK ASRFRC 001 User Manual

Remote Control Instruction Manual

Model No.: ASRFRC-001

A. Product Name: Remote Control

B. Product photo as below:

1. INDICATOR LIGHT; 2. "ON/OFF" Button; 3. "MODE" Button

C. Product dimensions: Approximate 92.0 mm(Length) X 40.0 mm(Width) X 15.7 mm(Height)

D. How to operate this Remote Control:

1. "ON/OFF" BUTTON: To control the light set ON and OFF. When press this button, the light set will be light up, and press this button again, the light set will be light off move in cycles.

2. "MODE" BUTTON: To select the light set effects per your favor. When press this button ONCE, the light set can be changed to next preset function per circulatory functions as the above function list shown.

There are many different functions can be preset in this remote control, please find the functions list on remote control panel as final settings.

3. "INDICATOR LIGHT": When press the "ON/OFF" button or "MODE" button, the indicator light will be on to show you this remote control works properly.

E. Product Electrical Specification:

 Battery Size Required: 23A (A23 / L1028)  Operating Voltage: 12V DC  Operating Ampere: 12mA  Operating Frequency: 433.92MHz

F. Manufacturer: All Seasons Electronics Lighting Limited

FCC Warning:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modiﬁcations to this device not explicitly approved by manufacturer could

void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.