Leaksmart HUB 3.0 User Manual

Item# 8850830

Hub 3.0 Installation
Instructions

Setting up your LeakSmart System is as simple as launching

the LeakSmart App and pairing your devices.

User Interface

A. Wi-Fi Button – To Reset the Wi-Fi credentials of the LeakSmart Hub 3.0.

B. Power ON/OFF – A Switch to turn ON/ turn OFF the LeakSmart Hub 3.0.
Note: Battery is only backup supply. User must use power adapter in order to switch ON the device.

C. Factory Reset – Factory reset the LeakSmart Hub 3.0.

Note: All the paired sensor devices will be removed after factory reset.

D. User Indication LED – Single RGB color LED is used to provide user indications to show system status.

LED User indications are dened as per below table:

•

Primary Supply – 5V DC adapter supply.

•

Secondary Supply – Battery supply.

User LED
Indication

Wi-Fi Button

_

Power On/O

Factory Reset

5v Power
Adapter Jack

+

page 1

Battery Compartment
(18350 Lion)

Hub Installation Instructions

Hub Operation

LED Indication Primary Supply Secondary Supply

Red No Wi-Fi Connection No Wi-Fi Connection

Red Blinking No Internet Access No Internet Access

Blue System is OK NA

Green Blinking Initializing Pairing Mode Initializing Pairing Mode

Green Firmware upgrade in progress Firmware upgrade in progress

Yellow-Orange NA System is OK, running on battery

Yellow-Orange Blinking NA LOW Battery

Light Purple Factory Reset in progress Factory Reset in progress

Red and Blue blinking Abnormal Condition Abnormal Condition

Setup and Operation

CAUTION: Read installation instructions BEFORE installing your
below show IOS application screen examples. The setup process is the same on an Android device, but the
app screens will appear dierent on an Android device.

1. Centrally locate the Hub in your home to get the best coverage. Ideal spot is
on the main level of your home.

2. Connect the power supply to the hub. Note: make sure the cord used, is identied
with a ag stating “Hub Only”.

3. Switch on the On/O switch. Once powered, a solid Red LED light will indicate
on the top of the hub.

page 2

LeakSmart

Hub. The setup instructions

Power
On/O

5v Power
Adapter Jack

User LED
Indication

Hub Installation Instructions

Setup and Operation

4. Download the LeakSmart app to your
smart device from the Apple App
Store or Google Play.

5. Create an account and password.
Once created, an activation link will
be sent to your account email
address.

Click the link in your email to launch
the LeakSmart app, then sign in.

6. On the home page of the LeakSmart
app, tap on add hub.

The app will then walk you through
the set up procedure.

page 3