Leaf & Bean G0000818 User manual

Goose Neck Kettle 800ml

G0000818
Instruction Manual

Thank you for choosing the Leaf & Bean Electric
Goose Neck Kettle.
To ensure proper operation and to maintain the
lifespan of your appliance, please read these
instructions carefully before use.

Product Overview

1. Lid

2. Handle

3. Stainless Steel Goose Neck Spout

4. Stainless Steel Body

5. Indicator Light

6. Power Base

7. On/Off Switch

1

2

3

4

5

7

6

Technical Information

Model G0000818

Voltage 220-240V~,

Power 1000W

Capacity 0.8 L

50/60Hz

Product Feature

1. Perfect taste for brewing coffee and tea.

2. Counterbalanced nonslip handle design.

3. Food-grade stainless steel 304.

4. Water level gauge inside.

5. Automatically shuts off when water boils.

6. Boil-dry and overheat protection.

Safety Instructions

• Before connecting kettle to the power
supply, check that the voltage indicated on
the appliance (under the kettle and base)
corresponds with the voltage in your home.
If this is not the case, contact your dealer
and do not use the kettle.

• In the case of obvious damage to the appli­ance or the cord, consult an electrician.

• This appliance is not to be used by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision.

• Never allow children to use electrical equip­ment without supervision.

• Avoid contact with steam coming from the
spout area when pouring. Also avoid the lid
area when refilling.

• Never use the appliance outside or exposed
directly in the environment.

• The boiler gets hot during use, therefore
do not touch the appliance except for
the handle.

• Do not fill above the ‘Max’ mark as water
may boil over and potentially splash out.

• Do not open the lid while water is boiling.

• Never place the kettle near or on
hot plates/gas burners.

• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or a similar qualified person to
avoid hazard.

• Use only on a dry, anti-slip and level surface.

• Never place the kettle, cord or plug in
any liquid.

• Never switch the appliance on when its lid
is open.

• Make sure the kettle is switched off before
lifting or pouring.

• Always unplug your kettle when not in use.

• If the kettle is overfilled, boiling water may
be ejected.

• Only use this appliance with the
stand provided.

• This appliance is for household and similar
applications only, such as farmhouses and
bed and breakfast-type environments.

• If there is no water in the kettle, do not start.
Otherwise, the stainless steel chassis will
change colour. Repeated dry burning will
reduce the life of this kettle.

• Only suitable for water – never put other
liquids in the kettle.

• Misuse of this appliance can potentially
cause injury.

• CAUTION: The heating element surface is
subject to residual heat after use.

• CAUTION: Do not operate the kettle on an
inclined surface. Do not operate the kettle
unless the element is fully immersed. Do
not move the kettle while it is switched on.

Packaging and Recycling

The materials used for this product’s
packaging can be reused, recycled, and
disposed of through specific waste streams.

• REUSE: Keep packaging to safely store
or transport your appliance, preventing
damage.

• RECYCLE: Look for recycling symbols on
packaging components to identify if they are
recyclable. Check with your local authorityto
find out what materials are accepted for
recycling in your area.

• DISPOSE: Look for symbols on packaging
components and dispose of materials
accordingly.

Before First Use

• Please read the instructions carefully before
use.

• Before using the kettle for the first time,
clean the interior thoroughly.

• Remove all packing materials (including the
plastic protector on the spout) and ensure
the product is in good condition.

• Keep the electrical components dry and
wipe the interior of the kettle with a damp
cloth.

• Rinse the inside of the kettle thoroughly with
water.

• Wipe the exterior of the kettle gently with a
damp cloth.

• Dry all parts completely.

• It is recommended to run one boiling cycle
before using the kettle.

Operating Instructions

• Remove the unit from the power base.

• Open the lid by pressing the button on the
top.

• Fill the kettle with your desired amount of
water, ensuring not to exceed the MAX line.

• Close the lid securely until it locks into
place.

• Place the kettle back on the power base,
ensuring it is correctly engaged.

• Connect the power cord to a power outlet
and turn on the power switch. The indicator
light will illuminate.

• The kettle will automatically switch off when
the water reaches a boil.

• Boiling can be stopped at any time by oper­ating the on/off switch.

Tips

• This appliance is only suitable for heating
and boiling water.

• Do not use any other liquids. The heating
element must be covered with water. Other­wise, there is danger of overheating

• Should the boil-dry protection operate, allow
the kettle to cool down. The appliance will
be ready for use once cooled.

• The water gauge will show how much water
there is in the jug.

• Never fill the kettle with any liquid other
than water.

• Never open the lid while the water is boiling.

• The stainless steel body will become ex­tremely hot.

Trouble Shooting

Error Fault Description Solutions

Power supply socket is not

Indicator light is
not on

Water takes too long to
boil

Indicator light is on but
not heating

Room leakage switch
trips after power is
turned on

energized

Ends of the power cord are not
plugged in

Supply voltage is too low

Water temperature is too low

Heating plate is damaged

Improper operation or water
in the bottom of the kettle
causing a short circuit in the
electrical components

Care Instructions

• Unplug the unit before cleaning and allow it
to cool down.

• Wipe the exterior of the kettle with a clean,
damp cloth, avoiding contact with electrical
components.

• To clean the interior, use a soft sponge and
soapy water to gently scrub. If your hand
cannot fit inside the kettle, swish warm,
soapy water around inside with the lid
closed.

• Scale buildup may occur over time due to
frequent use or water quality. It’s normal,
so it’s recommended to descale the kettle
weekly. Use vinegar or citric acid for descal­ing. Mix 2/3 water and 1/3 vinegar in the ket­tle, and the scale will disappear in minutes.
Boil the solution two or three times.

• Do not damage, excessively bend, stretch,
twist, or place heavy objects on the power
cord. Avoid pinching the cord.

• Place the electric kettle in a dry environ­ment; do not use it outdoors.

Check if the power socket is
energized.

Ensure both ends of the power
cord are securely connected.

Wait patiently for the kettle to
heat up.

Allow the kettle to heat
the water to the required
temperature.

Contact customer service for
assistance.

Contact customer service for
assistance.

Our 12 month Guarantee

Our goods come with guarantees that cannot
be excluded under the Australian Consumer
Law. You are entitled to a replacement or
refund for a major failure and compensation
for any other reasonably foreseeable loss
or damage. You are also entitled to have
the goods repaired if the goods fail to be of
acceptable quality and the failure does not
amount to a major failure.

We stand by this product. Therefore we
offer a 12 month guarantee on the heating
element. The benefits of this guarantee are in
addition to any rights and remedies imposed
by Australian Consumer Law. Our guarantee
excludes normal wear and tear and instances
where care and use instructions have not
been followed.

What IsAlbi will do:

During this guarantee period IsAlbi will
repair, replace or refund any defective
product. If identical product is not available
for replacement, a similar product may be
offered. IsAlbi asks you to cover the cost of
postage/transit if the product needs to be
sent back to us for inspection. If IsAlbi deems
the product is defective, we will reimburse
your postage/transit expenses. IsAlbi will
be responsible for the postage/transit of the
repaired/replacement product back to you.

IsAlbi
87 Chifley Drive, Preston, Victoria 3072
P: [phone]
E: [email protected]
www.isalbi.com.au

What to do:

If a fault/defect is identified cease using
the product immediately. To make a claim
on this guarantee, take the product, proof
of purchase and full details of the alleged
defect to the retailer from whom the product
was purchased. If you cannot access the
retailer or are unsatisfied with the solution
offered by the retailer contact IsAlbi via the
details below.