
D8046 Electric Milk Warmer & Frother
Operating Manual
Thank you for choosing the Davis & Waddell Leaf & Bean Electric Milk Warmer & Frother. To
ensure proper operation and to maintain the lifespan of your appliance, please read these
instructions carefully before use.
1. Key Features
Will froth 115ml of milk when used with the whisking insert
Will warm 240ml of milk when used with the stirring insert
From cold to hot milk in 80 seconds
Will automatically switch off when ready
2. Important Safety Instructions
When using electric appliances, especially when children are present basic safety
precautions should always be followed, including the following:
Read all the instructions before operating this appliance.
Children should be supervised to ensure they do not play with the appliance, and be
sure to keep them away from hot milk and jug.
Do not immerse in water or any other liquid
Unplug the appliance when not in use or being cleaned.
Pull out from the power outlet by grasping the plug, never by the cord.
Keep away from moving parts
Always check the integrity of the cord before use, if the cord or plug is damaged do
not use.
This appliance should be kept away from hot gas, heated oven, electric burner or any
hot surface
The appliance should always be used on a hard stable surface, such as table or
benchtop.
Take care when the appliance is in use or has just been used as it becomes hot and
may cause burns or scalding, always use the handle.
Do not operate without milk in the jug
By exceeding the filling capacity the jug may overflow
This appliance is intended for household use, not commercial use.
Store these instructions for future reference.

4. Jug: S/S Housing
Non-stick coating inside
8. Whisking insert
For frothing milk
9. Stirring Insert
For heating milk

4. Operation Instructions
Before using the appliance for the first time please clean and dry the jug and accessories
thoroughly.
Choose the appropriate insert and set it inside the jug, see the function below for reference.
Pour the milk into the jug to the appropriate fill line, see below for reference
Push the button to start the machine
Frothing & Heating/Heating: touch the button and the blue and red lights will turn
on, the red light keeps flashing for 30 seconds, the blue light will turn off when your
milk is ready, the machine will automatically turn off at the same time.
Frothing cold milk: pour the cold milk into the jug and push the button for 1-2
seconds until the blue light turns on. After 80 seconds the machine finishes, the blue
light turns off and the red light will flash for 30 seconds
Heating
(a small amount of froth)

For best results
Always use your frother first to froth or heat your milk. While it is operating prepare
your coffee or hot chocolate and serve immediately
Use low-fat milk for best frothing results
Cold milk can be frothed in this appliance but it won’t keep it chilled
Milk heats to approximately 65-70C. This is the ideal temperature to ensure the best
flavour of your coffee.
Keep the whisks in a safe place, they are small and can be easily lost
After frothing and heating allow 2 minutes for the thermostat to reset and the
frother to be ready for use again. To shorten this time, rinse with water and wipe dry
after each use.
The frother is designed to heat and froth milk, if you add flavourings, coffee granules
or hot chocolate powder, in the frother be sure to thoroughly clean immediately
after use.

5. Care
Do not immerse in water and do not use any detergents, just wipe the base with a
damp cloth or towel. To clean the jug and inserts rinse out with water.
Not dishwasher safe
Do not leave the appliance in a damp or steamy environment
This appliance is operated by an electric motor; there is no need to use lubrication
for any moving parts, motor, bearings or sharpening surfaces.
6. Troubleshooting
Indicator light
doesn’t work, jug
doesn’t work
1、Plug is not inserted properly.
2、Jug and power base has poor
contact.
Check the jug and try again
3、No power supply to the outlet
Check the electric circuit
4、Problem with components
Jug ceases to work
after starting
operation
1、Jug temperature is too high
Rinse with cold water inside the
jug to reduce temperature
2、Jug damaged with immersion in
water
No longer use it, this is not
covered by guarantee
1、Jug not cleaned in good time
after use, milk locks the mechanism.
Clean and move the shaft sleeve
of motor by hand to loosen it.
1、Dosage of milk either too little or
too much
Use the dosage of milk
according to the dial
2、Jug reused without cleaning
Always clean in good time after
use
3、Actual voltage much lower than
specified voltage
Use the appropriate voltage

7. Guarantee
If after following these instructions the milk frother does not work, there may be a
manufacturing problem. If this is the case, Albi guarantees this product for 1 year from the
date of purchase. The full details of this guarantee can be found at www.albi.com.au or by
calling (03) 9474 1300. In the event of such a problem you should return it to the place from
which you bought it, WITH PROOF OF PURCHASE, in the form of a valid receipt. Damage
through misuse will nullify this guarantee.
For any other advice please contact:
Customer Service
Albi
87 Chifley Drive,
Preston Vic 3072